Abstract
Based on a series of experiments, the relationships between normal component forces and oblique angles of cutting edge, and normal rake angles in oblique cutting of wood were studied. The experiments consist both of the 90°-0° and the 0°–90° oblique cutting situation. Each type of experiment includes two wood species and two kinds of thickness. Through the experiments, the rules of the effect of oblique angles of cutting edge and normal rake angles on normal component force were found out. The calculation methods of normal component force were studied by mathematical analysis.
Zusammenfassung
Auf experimenteller Basis wurden die Beziehungen zwischen der Normal-Kraftkomponente und dem Winkel der Schneidekante sowie dem Freiwinkel beim, Schneiden von Holz mit schrägstehendem Messer untersucht. Die Schneidebedingungen wurden jeweils in den Positionen zwischen 90° und 0° bzw. zwischen 0° und 90° gewählt. In allen Experimenten wurden jeweils zwei Holzarten (Kiefer und Birke) und zwei unterschiedliche Probendicken verwendet. Die gefundenen Beziehungen für die Normal-Kraftkomponenten konnten als lineare Regressionsgleichungen formuliert werden.
Similar content being viewed by others
References
Jin, W.;Cai L. 1996: Study on the normal component force in oblique cutting of wood. Holz Rohwerkstoff 54: 283–286
Jin, W. 1987: Study on the oblique cutting of wood. Journal of Northeast Forestry University, 15: 47–54
Ozaki, S.;Fukui, H. 1985: The oblique cutting of wood III. Mokuzai Gakkaishi J. Japan wood Res. Soc. 31(5): 354–360
Wan, Y. 1983: Cutting principle of wood, Harbin.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Jin, W., Cai, L. Study on the normal component force in oblique cutting of wood. Holz als Roh-und Werkstoff 55, 118–120 (1997). https://doi.org/10.1007/BF02990528
Issue Date:
DOI: https://doi.org/10.1007/BF02990528