Abstract
QOS (Quality Of Service) parameter definitions are the basis of further QOS control. But QOS parameters defined by organizations such as ISO and ITU are incoherent and incompatible. It leads to the inefficiency of QOS controls. Based on the analysis of QOS parameters defined by ISO and ITU, this paper first promotes Minimum QOS Parameter Set in transport layer. It demonstrates that the parameters defined by ISO and ITU can be represented by parameters or a combination of parameters of the Set. The paper also expounds that the Set is open and manageable and it can be the potential unified base for QOS parameters.
This is a preview of subscription content, log in via an institution to check access.
References
Yeh W P, Hammond J L, Tipper D. Design and evaluation of a method for admission control for broadband packet networks.Computer Networks and ISDN Systems, 1995, 27.
ISO 8072-1986/A6-15 (First Edition).
Stefan Bocking. TIP’s performance quality of service.IEEE Communications Magazine, August 1995.
Author information
Authors and Affiliations
Corresponding author
Additional information
The project is supported by the National “863” Hi-Tech Programme of China.
Wang Yun received her MSc and Ph.D degrees both in Computer Network & Communication from Southeast University in 1994 and 1997 respectively. Her main research interests are QOS, distributed processing, integrated framework and platforms.
Gu Guanqun is a Professor in Southeast University. His main research interests are high performance network, CIMS, etc.
Rights and permissions
About this article
Cite this article
Wang, Y., Gu, G. Minimum QOS parameter set in transport layer. J. of Comput. Sci. & Technol. 12, 571–573 (1997). https://doi.org/10.1007/BF02947209
Received:
Revised:
Issue Date:
DOI: https://doi.org/10.1007/BF02947209