Abstract
Piezoelectric transducers for dynamic overpressure measurements are commonly calibrated with static or quasistatic loads and the calibration is extrapolated to frequencies up to 30% of the resonant frequency of the piezoelectric crystal. Sinusoidal pressure generators are also used for dynamic calibration up to 500 Hz in the range of 3 MPa. This paper describes a method for dynamic calibration using transient overpressures, with rise time of 2 µsec and width 40 µsec, generated by exploding wires in air. The calibration is done in the range of 600 kPa.
Similar content being viewed by others
References
Compendium on Endevco, Endevco Tech. Paper TP-268 (M/s Endevco, USA)
Holman J P 1971Experimental methods for engineers (Kogakusha: McGraw Hill) 2nd edn
Menzel D H (ed.) 1960Fundamental formulas of physics (New York: Dover) Vol. 1
Swift G W, Migliory A, Carret S R and Whealtey J C 1982Rev. Sci. Instrum. 53
Vantine H C, Enickson L M and Johnson J A 1980J. Appl. Phys. 51 1957
Washburn E W (ed.) 1929International critical tables (New York: McGraw Hill) Vol. 5, p. 81
Zel’dovich Ya B and Raizer Yu P (eds) 1966Physics of shock waves and high temperature hydrodynamic phenomena (New York: Academic Press)
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Harvey, J., Nandakumar, J. & Krishnan, L.V. Dynamic calibration of shock overpressure transducers. Pramana - J. Phys 22, 447–451 (1984). https://doi.org/10.1007/BF02847111
Received:
Revised:
Issue Date:
DOI: https://doi.org/10.1007/BF02847111