Abstract
We study the influence of combined loading on the dynamic creep of AMg6 alloy and analyze the reliability of the description of this process within the framework of the known models. It was discovered that the process of dynamic creep cannot be satisfactorily described on the basis of these models. We propose an approach to the prediction of the influence of the level of stresses on the dynamic creep of AMg6 alloy based on the Rabotnov theory and the dependence of reduced dynamic creep on the load ratio. The results obtained on the basis of this approach are in good agreement with the experimental data.
Similar content being viewed by others
References
Yu. N. Rabotnov,Creep of Structural Elements [in Russian], Nauka, Moscow (1966).
D. Breslavs'kyi, “Equation of state for the process of creep of metallic materials under the conditions of rapid cyclic loading,”Visn. Ternopil. Derzh. Tekhn. Univ.,3, No. 1, 32–38 (1998).
W. Blum, P. Portella, and R. Feilhauer, “Festigkeit und Verformung bei hoher Temperatur,” in: B. Ilschner (editor).Deutsche Gesellschaft für Metallkunde (1983), p. 41.
P. Lukas, L. Kunz, and V. Sklenicka, “Interaction of high-cycle fatigue with high-temperature creep,” in:Strength of Materials, Japan Institute of Metals (1994), pp. 17–24.
“Interaction of high-cycle fatigue and creep in 9% Cr−1% Mo steel at elevated temperature,”Fatigue Fract. Eng. Mater. Struct.,18, No. 1, 27–35 (1995).
N. N. Malinin,Applied Theory of Plasticity and Creep [in Russian], Mashinostroenie, Moscow (1975).
Additional information
Pulyui Ternopil State Technical University, Ternopil. Translated from Fizyko-Khimichna Mekhanika Materialiv, Vol. 36, No. 1, pp. 43–46, January–February, 2000.
Rights and permissions
About this article
Cite this article
Yasnii, P.V., Halushchak, M.P., Fedak, S.I. et al. Cyclic creep of AMg6 alloy. Mater Sci 36, 48–53 (2000). https://doi.org/10.1007/BF02805116
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF02805116