Abstract
The problem of rational designing of ceramic and metalloceramic dentures is considered. The evaluation of the stress-strain state and the solution of the boundary inhomogeneous elastoplastic problem are used for determining the critical values of the amplitudes of all-ceramic cusps. The effect of the basis of the inhomogeneous structure on the changes in the angles of critical loads at which the prosthesis functions reliably up to the appearance of irreversible phenomena (cleavage of the ceramics, basis fracture) is estimated.
Similar content being viewed by others
References
E. N. Chumachenko, I. Yu. Lebedenko, S. E. Chumachenko, and V. A. Kozlov, “Mathematical modeling of the stress-strain state of metalloceramic structures of dental bridges,”Vestn. Mashinostr., No. 10, 12–18 (1997).
E. N. Chumachenko,Automatization of the Solution of Problems of the Theory of Low Elasoplastic Deformations in Modeling the Behavior of Special-Purpose Structures [in Russian], MGIEM, Moscow (1996).
V. N. Kopeikin,A Guide to Orthopedic Stomatology [in Russian], Meditsina, Moscow (1993).
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Chumachenko, E.N., Arutyunov, S.D., Gorbunova, A.N. et al. Calculation of admissible amplitude of unevenness on the functional surfaces of special all-ceramic and metalloceramic structures. Refract Ind Ceram 39, 249–253 (1998). https://doi.org/10.1007/BF02765076
Issue Date:
DOI: https://doi.org/10.1007/BF02765076