Abstract
Causes of uncertainties in calibration of measuring instruments are considered. On the base of results of statistical analysis, generalized diagrams are given for determining the limiting accuracy of calibration of microwave instruments measuring phase, attenuation, and reflectivity.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Gosudarstvennaya sistema obespecheniya edinstva izmerenii. Normirovanie i ispol’ zovanie metrologicheskikh kharakteristik sredstv izmerenii (State-Controlled System for Support of Universality of Measurements. Standardization and Utilization of Metrological Characteristics of Measuring Instruments), GOST 8.009-84, Moscow: Izd. Standartov, 1988.
GOST 16253-70 GSI. Metrologiya. Terminy i opredeleniya (State System of Measurement. Metrology. Terms and Definitions), Moscow, 1970.
Malikov, N.F.,Osnovy metrologii (Principles of Metrology), Moscow, 1949.
Tsvetkov, E.I., Principles of Formalized Description of Measurement Procedures,Izmereniya, kontorl’, avtomatizatsiya, 1986, no. 3(59), pp. 11–17.
Rozenberg, V.Ya.,Vvedenie v teoriyu tochnosti izmeritel’ nykh sistem (Introduction to Theory of Accuracy of Measuring Instruments), Moscow: Sovetskoe Radio, 1975.
GOST 233480-79.Kontrol’ nerazrushayushchii radiovolnovoi. Metody radiovolnovogo vida. Obshchie trebovaniya (Radiowave NDT. Methods of Radiowave Type. General Conditions), Moscow: Izd. Standartov.
GOST 25513-82. Kontrol’ nerazrushayushchii radiovolnovoi. Terminy i opredeleniya (Radio-Wave NDT. Terms and Definitions), Moscow: Izd. Standartov.
Vorob’ev, E.A.,Konstruirovanie ustroistv SVCh (Designing Microwave Instruments), Leningrad: Sudostroenie, 1985.
Vorob’ev, E.A.,Raschet proizvodstvennykh dopuskov ustroistv SVCh (Calculation of Tolerances in Microwave Instruments), Leningrad: Sudostroenie, 1980.
Vorob’ev, E.A., Technological Limitations in Commercial Production of Typical Microwave Instruments,Voprosy radioelektroniki, ser. TPO, 1976, no.2, pp. 113–127.
Vorob’ev, E.A., Design and Technological Limitations on Miniaturization of Microwave Instruments,Voprosy radioelektroniki, ser. TPO, 1978, no. 3, pp. 51–64.
Vorob’ev, E.A., Precision Criteria for Calibration and Measurements in Microwave Band in System of Technological Support,Trudy LIAP, 1971, no. 70, pp. 40–46.
Vorob’ev, E.A., Basic Precision Criteria in Microwave Band Necessary for Designing Measuring Instruments,Materialy VI NTK Radiometriya-75 (Proc. of 6th Conf. Radiometery-75), vol. 4, Kaunas-Vilnyus, 1975, pp. 52–60.
Vorob’ev, E.A., Feasibility Study of Design Characteristics Needed for Required Information Content of Testing Data,Defektoskopiya, 1996, no. 4, pp. 77–83.
Vorob’ev, E.A.,Radiovolnovoi kontrol’ radiotekhnicheskikh konstruktsii i materialov (Radiowave Testing of Electronic Components and Materials), Leningrad: Sudostroenie, 1986.
Vorob’ev, E.A., Method of Radiowave Testing of Functional Surface Roughness of Microwave Devices,Defektoskopiya, 1998, no. 4, pp. 64–70.
Alyab’ev, E.G.et al., High-Precision Instrument for Measuring Complex Reflectivity of Electromagnetic Waves in Rectangular Waveguides,Izmeritel’ naya Tekhnika, 1999, no. 11, pp. 49–50.
Negurei, A.V. and Egorov, V.I., Errors in Precision Waveguide Reflection Phase Shifters, inKonstruirovanie REA. Mezhvuzovskii sbornik nauchnykh trudov (Designing Radio-Electronic Devices. Collection of University Research Papers), Leningrad: LIAP, 1989, pp. 12–17.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Vorob’ev, E.A. Uncertainties in calibration of radiowave testing instruments. Russ J Nondestruct Test 36, 509–514 (2000). https://doi.org/10.1007/BF02759433
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF02759433