Abstract
The high temperature deformation of vacuum-melted iron and zone-refined iron has been studied in the temperature range 500° to 800°C over a wide range of strain rates in torsion. Changes in stress-strain behavior and metallographic observations show a transition in the dynamic restoration process from recovery at high stresses to recrystallization at low stresses. The results are discussed in terms of a model for dynamic recrystallization. It is shown that the dependence of the critical strain for the onset of recrystallization on experimental conditions is the most important factor in determining the deformation characteristics.
Similar content being viewed by others
References
C. Crussard and R. Tamhankar:Trans. TMS-A1ME, 1968, vol. 242, p. 1619.
A. Lawley, J. A. Coll, and R. W. Cahn:TMS-AIME, 1960, vol. 218, p. 166.
D. McLean and K. F. Hale: Iron and Steel Inst., London, Spec. Report No. 70, 1961, p. 19.
R. A. Reynolds and W. J. McG. Tegart:J. Iron Steel Inst., 1962, vol. 200, p. 1044.
E. Bull Simonsen and J. M. Dossin:J. Iron Steel Inst., 1965, vol. 203, p. 380.
Y. Ishida, C. Y. Cheng, and J. E. Dorn:Trans. TMS-AIME, 1966, vol. 236, p. 964.
S. Karashima, H. Oikawa, and T. Watanabe:Acta Met., 1966, vol. 14, p. 791.
A. Goldberg:J. Iron Steel Inst., 1966, vol. 204, p. 268.
J. L. Robbins, O. C. Shepard, and O. D. Sherby:Trans. ASM, 1967, vol. 60, p. 205.
W. T. Evans and B. Wilshire:Trans. TMS-AIME, 1968, vol. 242, p. 1303.
R. W. Evans and L. A. Simpson:Phil. Mag., 1969, vol. 14, p. 809.
J. Cadek and K. Milicka:Czech. J. Phys., 1968, vol. B 18, p. 1156.
K. Ciha, K. Milicka, and J. Cadek:Kovove, Materialy, 1968, vol. 6, no. 1, p. 91.
J. L. Uvira and J. J. Jonas:Trans TMS-AIME, 1968, vol. 242, p. 1619.
D. M. Keane, C. M. Sellars, and W. J. McG. Tegart: Iron and Steel Inst., London, Spec. Report No. 108, 1968, p. 21.
G. A. Redfern and C. M. Sellars: Iron and Steel Inst., London, Spec. Report No. 108, 1968, p. 29.
H. W. Wagenaar: Iron and Steel Inst., London, Spec. Report No. 108, 1968, p. 38.
J. Cadek, M. Pahutova, K. Chiha, and T. Hostinský:Acta. Met., 1969, vol. 17, p. 803.
J. Beech, B. A. Hands, and P. P. Mohla:Metallurgia, 1967, vol. 76, p. 175.
W. A. Marshall:J. Electrodep. Tech. Soc., 1952, vol. 28, p. 27.
C. Rossard and P. Blain:Rev. Mét., 1958, vol. 55, p. 573.
D. S. Fields and W. A. Backofen:Proc. ASTM, 1957, vol. 57, p. 1259.
J. J. Jonas, C. M. Sellars, and W. J. McG. Tegart:Met. Rev., 1969, vol. 14, p. 130.
M. J. Luton and C. M. Sellars:Acta. Met., 1969, vol. 17, p. 1033.
J. P. Sah, G. J. Richardson, and C. M. Sellars:Aust. Inst. Metals, 1969, vol. 14, no. 4, p. 292.
G. Glover and C. M. Sellars:Met. Trans., 1972, vol. 3, p. 2271.
J. J. Jonas, D. R. Axelrad, and J. L. Uvira:Suppl. Trans. Jap. Inst. Met., 1968, vol. 9, p. 257.
G. A. Redfern and C. M. Sellars:J. Iron Steel Inst., 1970, vol. 208, p. 576.
C. Antonione, G. Della Gatta, and G. Venturello:Trans TMS-AIME, 1964, vol. 230, p. 700.
S. K. Mitra and D. McLean:Proc. Roy. Soc., 1966, vol. 295(A), p. 288.
Author information
Authors and Affiliations
Additional information
This paper is based upon a thesis submitted by G. GLOVER in partial fulfillment of the requirements of the degree of Doctor of Philosophy at the University of Sheffield.
Rights and permissions
About this article
Cite this article
Glover, G., Sellars, C.M. Recovery and recrystallization during high temperature deformation of α-iron. Metall Trans 4, 765–775 (1973). https://doi.org/10.1007/BF02643086
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF02643086