Abstract
This paper reports a preliminary investigation into the feasibility of determining fire causes by analysis of the tensile properties of metals.
Similar content being viewed by others
Biblography
Doebelin, E. O.,Mechanical Engineering 570 Laboratory Manual, The Ohio State University publication (1974), p. 51.
Halliday, David and Renick, Robert,Physics for Students of Science and Engineering (John Wiley Sons, & Inc., New York, 1965), p. 685.
1971 Annual Book of ASTM Standards, Part 31 (American Society for Testing and Materials, Philadelphia, 1971), p. E-8, 3.2.5.
Metals Handbook, Volume 1 (American Society for Metals, Metals Park, Ohio, 1964), p. 1008.
Doebelin, E. O.,Measurement Systems Application and Design (McGraw-Hill, New York, 1972), p. 187.
Instron Operating Instructions, Instron Universal Testing Instruments, p. 2.
1971 Annual Book of ASTM Standards, Part 5 (American Society for Testing and Materials, Philadelphia, 1971), p. B3-63.
Homan, J. P.,Heat Transfer (McGraw-Hill, New York, 1975), p. 60.
Pollack, H. W.,Materials Sciences and Metallurgy (Reston Publishing Co., Reston, Va., 1973).
Additional information
Note: This paper is based on studies performed at The Ohio State University. Dr. Guenther is Assistant Professor of Mechanical Engineering, The Ohio State University, Columbus, Ohio, and Director of Engineering, Systems Engineering Associates, Columbus, Ohio. D. L. McGarry is Manager, Metallurgical Engineering; R. P. Shearer is Manager, Electrical Engineering; and R. C. MacCleary is an Electrical Engineer. All are with Systems Engineering Associates, Columbus, Ohio.
Rights and permissions
About this article
Cite this article
Guenther, D.A., McGarry, D.L., Shearer, R.P. et al. Fire analyses from mechanical properties. Fire Technol 12, 173–185 (1976). https://doi.org/10.1007/BF02624793
Issue Date:
DOI: https://doi.org/10.1007/BF02624793