Zusammenfassung
Die routinemäßig geprüften, genormten Standardeigenschaften von Spanplatten (Biegefestigkeit, Querzugfestigkeit und Dickenquellung) reichen nicht aus, um die Eignung von industriell hergestellten Spanplatten im Hinblick auf bestimmte Anwendungszwecke zu beurteilen. Sie geben auch zu wenig Hinweise auf die Weiterentwicklung der Verfahrenstechniken und müssen daher durch weitere Prüfungen ergänzt werden. Fast alle Spanplatteneigenschaften sind mittelbar oder unmittelbar von der Rohdichte abhängig, so daß diese als eine zentrale Eigenschaft zu betrachten ist. Da es aber nicht genügt, nur die mittlere Rohdichte einer Platte als Variable aufzufassen, wurde deren Verteilung in Richtung der Flächennormalen, das sogenannte Rohdichteprofil, herangezogen. Zwischen dem Rohdichte- und dem Querzugprofil konnten Korrelationen nachgewiesen werden, deren Bestimmtheit dem Grenzwert 1 sehr nahe kommt. Die Zusammenhänge zwischen der Struktur der Spanvliese, der Steuerung der Pressen und dem Leimvorgängen einerseits und dem Rohdichteprofil andererseits wurden aufgezeigt und erörtert. Das Rohdichteprofil erwies sich als ein aufschlußreiches, leicht meßbares Beurteilungsmerkmal für die gesamte Verfahrenstechnik.
Summary
Routine tests in which the standardized properties of particle-board (bending strength, tensile strength perpendicular to the surface, and thickness swelling) are investigated do not supply sufficient information in order to judge the suitability of industrially manufactured particleboard for specific fields of application. The information they give on the further development of the technology of manufacture is scarce; therefore, they have to be supplemented by further tests. Almost all particleboard properties are directly or indirectly dependent on the distribution of density over the cross section of the board (profile density). Profile density may thus be considered a very important property. Since it does not suffice to take the average board density as a variable, the density distribution towards the normal of the plane surface, the so-called density profile, was used. Correlations were found between the profile of density and the profile of tensile strength, the coefficient of determination of which closely approaches the threshold value1. The relations between structure of the carpet, control of the presses, and gluing procedures on the one hand and density profile on the other are shown and dealt with. The density profile proved to be an instructive and easily measurable criterion for the whole technology of manufacture.
Schrifttum
Fahrni, F. 1942. Verfahren zur Herstellung von Kunstholzplatten. DBP 967 328, 1942
Himmelheber, M. 1948. Arbeiten der Holig-Homogenholzwerke GmbH auf dem Gebiet der Holzwerkstoffe; Bericht Nr. 31 des Vereins für technische Holzfragen, Braunnschweig
Plath, E. 1971. Beitrag zur Mechanik der Holzspanplatten. Holz Roh- Werkstoff29: 337–382
Author information
Authors and Affiliations
Additional information
Mitteilung aus dem Laboratorium der Dr. E. Schnitzler GmbH & Co. Industrieplanung, Karlsruhe
Rights and permissions
About this article
Cite this article
Plath, E., Schnitzler, E. Das Rohdichteprofil als Beurteilungsmerkmal von Spanplatten. Holz als Roh-und Werkstoff 32, 443–449 (1974). https://doi.org/10.1007/BF02612838
Issue Date:
DOI: https://doi.org/10.1007/BF02612838