Abstract
By the method of hardness testing, it is experimentally demonstrated that, in the process multi-cycle treatment, the gradient of hardening of the surface layer of a workpiece is practically perpendicular to the surface. The engineering solution of the problem of stressed state in the contact zone is obtained by the method of slip lines. The accuracy of this solution is estimated. The strained state is studied by the method of dividing grids. On the basis of an analysis of the history of deformation, we deduce a simple engineering formula for the evaluation of the elapsed plasticity limit according to the Kolmogorov criterion.
Similar content being viewed by others
References
D. E. Zaitsev, V. D. Del’, and G. D. Del’, “Stressed state in the process of drawing with deformation,”Vestn. Mashinostr., No. 6, 34–36 (1973).
Yu. S. Rostotskii,Serviceability of the Working Elements of Broaches Hardened by Electric-Spark Alloying [in Russian], Author’s Abstract of the Candidate Degree Thesis (Technical Sciences), Kiev (1992).
Yu. A. Tsekhanov,Mechanics of Drawing with Deformation as a Scientific Basis for the Assessment of the Quality of Workpieces and Serviceability of Tools with Wear-Resistant Coatings [in Russian], Author’s Abstract of the Doctoral Degree Thesis (Technical Science), Voronezh (1993).
G. D. Del’,Evaluation of Stresses in the Plastic Zone According to the Distribution of Hardness [in Russian], Mashinostroenie, Moscow (1971).
Author information
Authors and Affiliations
Additional information
Translated from Problemy Prochnosti, No. 3, pp. 86–94, May–June, 2000.
Rights and permissions
About this article
Cite this article
Tsekhanov, U.A., Sheikin, S.E. & Balaganskaya, E.A. Kinematics of the surface layer in the process of drawing with deformation. Strength Mater 32, 270–276 (2000). https://doi.org/10.1007/BF02509855
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF02509855