Journal of Mining Science

, Volume 27, Issue 4, pp 329–332 | Cite as

Design of impact working elements for excavation of slot headings

  • B. R. Rakishev
  • V. S. Bobovich
  • I. R. Gurevich
Mechanization and Automation of Mine Working
  • 25 Downloads

Conclusions

  1. 1.

    It is recommended to drive a slot heading with formation of lead faces in the near-wall areas followed by the breaking of the pillar remaining in the middle part of the working. The lead face should be 10–20 mm wide. The pillar exposure degree should be 1.15–1.55.

     
  2. 2.

    The performance of the slot formation process Π∼A3/2n, where A is a unit stroke energy and n is the stroke frequency. Therefore, it is more efficient to increase the energy of a single stroke rather than the stroke frequency.

     
  3. 3.

    The optimum criterion for the parameters of the impact system with the electro-mechanical drive is the maximum value of the ratio A3/2n.

     

Keywords

Rock Burst Impact System Slot Width Pillar Width Single Stroke 

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

Literature Cited

  1. 1.
    B. R. Rakishev, V. S. Bobovich, and I. R. Gurevich, “Parameters of interaction in the cutting of slot workings by direct impact,” Fiz.-Tekhn. Probl. Razrab. Polezn. Iskop., No. 1 (1989).Google Scholar
  2. 2.
    G. V. Artsimovich, E. P. Poladko, and I. A. Sveshnikov, Studies and Development of Rock Breaking Tools for Drilling [in Russian], Nauka, Novosibirsk (1978).Google Scholar
  3. 3.
    V. B. Sokolinskii, Impact Destruction Machines [in Russian], Mashinostroenie, Moscow (1982).Google Scholar

Copyright information

© Plenum Publishing Corporation 1992

Authors and Affiliations

  • B. R. Rakishev
  • V. S. Bobovich
  • I. R. Gurevich

There are no affiliations available

Personalised recommendations