Abstract
The primary aim of the research which is described in this paper was to investigate the effect of lateral pressure on the bond strength of deformed reinforcement set in normal weight concrete. A large number of tests was undertaken in which the main variables affecting bond strength were investigated. These included concrete strength, reinforcing bar diameter, concrete cover, lateral pressure, position of casting and bar spacing. A brief review of the small number of earlier investigations involving lateral pressures is provided. The paper provides details of the test specimens, the test apparatus and procedure, as well as typical results selected from approximately three hundred results. It draws conclusions on the appropriateness of the test method and the effects of the variables on the bond stress ratio and on bond strength.
Résumé
Le but principal de ces recherches était d'étudier l'effet de l'effort tranchant sur l'adhérence des armatures crantées placées dans du béton ordinaire. Un grand nombre d'essais ont été effectués pour étudier les principales variables qui influencent l'adhérence, y compris la résistance du béton, le diamètre des barres de renforcement, l'épaisseur d'enrobage, l'effort tranchant, la mise en place et le positionnement des barres. On résume le petit nombre de recherches antérieures sur ce sujet. L'article décrit les éprouvettes, l'appareillage et les procédures d'essais, ainsi que des résultats types choisis parmi environ 300 résultats d'essais. Il présente des conclusions sur l'applicabilité de la méthode d'essais et les effets des variables sur le rapport contrainte d'adhérence et sur l'adhérence.
Similar content being viewed by others
References
Untrauer, R.E. and Henry, R. L., ‘Influence of normal pressure on bond strength’,ACI Journal Proceedings (62–36) (1965) 577–585.
Robins, P.J. and Standish, I.G., ‘Effect of lateral pressure on bond of reinforcing bars in concrete’ in ‘Bond in Concrete’, Proceedings of an International Conference, Paisley College of Technology, June 1982 (Applied Science Publishers, 1982) 262–272.
Robins, P.J. and Standish, I.G., ‘The Influence of lateral pressure upon anchorage bond’,Magazine of Concrete Research 36 (129) (1984) 195–202.
CEB Bulletin d'Information No 151: ‘Bond Action and Bond Behaviour of Reinforcement’-State-of-the-Art, Report (Comité Euro-International du Béton, Paris, France, April 1982) 1–153.
Schmidt-Thrö, G., Stökl, S. and Kupfer, H., ‘Verankerung der Bewehrung am Endauflager bei Einachsiger Querpressung’ (Anchorage of Reinforcement at an End Bearing with Uniaxial Lateral Pressure'), (Lehrstuhl für Massivbau, Institut für Baiungenieurwesen III, Technische Universität, München, Mai 1986).
Schmidt-Thrö, G., Stökl, S. and Kupfer, H., ‘Einflu Einer Einachsigen Querpressung und der Verankerungslänge auf das Verbundverhalten von Rippenstählen in Beton’ (‘Influence of Uniaxial Lateral Pressure and the Length of Anchorage on the Bond Behaviour of Deformed Bars in Concrete’),Ibid.( August 1986.
Nagatomo, K. and Kaku, T., ‘Bond behaviour of deformed bars under lateral compressive and tensile stress’ in ‘Bond in Concrete’, Proceedings of an International Conference, Riga Techical University, October 1992, (Riga Technical University, Riga, Latvia, 1992) 1/69–1/78.
Malvar, L.J., ‘Confinement stress dependent bond behaviour, Part 1: Experimental investigation’ in ‘Bond in Concrete’,Ibid. ) 1/79–1/88.
Cox, J.V. and Hermann, L.R., ‘Confinement Stress Dependent Bond Behaviour, Part II: A Two Degree of Freedom Plasticiy Model’ in ‘Bond in Concrete’Ibid. ) 11/11–11/20.
CEB Bulletin d'Information No 204: ‘Final Draft of Model Code 1990’ (Comité Euro-International du Béton-Fédération Internationale de la Précontrainte, Paris, France, July 1991).
Batayneh, M.K., ‘The Effects of Lateral Compression on Bond Between Deformed Reinforcing Bars and Concrete’, Dissertation submitted in partial fulfilment of the requirement for the award of PhD. of Oxford Brookes University (1993).
BS4449: ‘Specification for Carbon Steel Bars for the Reinforcement of Concrete’ (British Standards Institution, London, England, 1988).
BS8110 Part I: ‘The Structural Use of Concrete’ (British Standards Institution, London, England, 1985).
Author information
Authors and Affiliations
Additional information
Editorial note Prof. Dr. P. E. Regan is a RILEM Senior Member and a member of the Editorial Group of TC 090-FMA, Fracture Mechanics of concrete-Applications.
Rights and permissions
About this article
Cite this article
Walker, P.R., Batayneh, M.K. & Regan, P.E. Bond strength tests on deformed reinforcement in normal weight concrete. Mat. Struct. 30, 424–429 (1997). https://doi.org/10.1007/BF02498566
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF02498566