Conclusions
-
1.
From the results of pit investigations the authors have determined approximate values for the energy parameters of the effector units of a machine with high-energy percussive rock breaking. The effector unit of an entry-driving machine for hard rocks cutting workings 15 m2 in cross section should have an impact energy of 20,000 kgf·m and a frequency of 60 min−1.
-
2.
The authors give analytical relations for the size of the effector unit and the frame of an entry-driving machine with high-energy breaking.
Similar content being viewed by others
Literature Cited
B. V. Voitsekhovskii, L. A. Mitin, and F. F. Voitsekhovskaya, “Efficiency of high impact energies for breaking hard ledge rocks,” Fiz.-Tekh. Probl. Razrab. Polezn. Iskop., No. 4 (1974).
High-Energy Impact Rock Breakage: Research Program Annual Report, March, 1972, Report TM-7204, Ingersoll-Rand.
Institute of Nonferrous Metallurgy Information (Institut Tsvetmetinformatsiya), Brief Communications, Series 1, Mining, No. 25 [in Russian], October 10, 1974.
F. F. Voitsekhovskaya and L. A. Mitin, “Wear resistance of a percussive bit and influence of impact parameters on the indices of fracture of rocks (experimental investigations in pit conditions),” in: Aspects of Hydroimpulsive Technique [in Russian], No. 1, Novosibirsk (1970).
Experimental Investigations in Pit Conditions of the Process of Percussive Rock Breaking: Report of Institute of Hydrodynamics and Special Constructional Bureau of GIT [in Russian], Novosibirsk (1969).
Author information
Authors and Affiliations
Additional information
Translated from Fiziko-Tekhnicheskie Problemy Razrabotki Poleznykh Iskopaemykh, No. 6, pp. 51–54, November–December, 1976.
Rights and permissions
About this article
Cite this article
Mitin, L.A., Fadeev, P.Y., Fadeev, V.Y. et al. Characteristics of a cutter-loader with a percussive effector unit. Soviet Mining Science 12, 604–607 (1976). https://doi.org/10.1007/BF02497454
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/BF02497454