Abstract
A realistic calculation and dimensioning of plastic material structures has to consider the variations of the actions upon the structure as well as the behaviour variations of the plastic materials used. The calculation method based on the limiting states presupposes the determination of standard values as well as uniformity and adaptation factors for the plastic materials.
The relevant research problems are described.
Similar content being viewed by others
References
Risse J.—Grundlagen der Berechnung von Plastkonstruktionen nach der Methode der Grenzzustände (Fundamentals for Calculation of Plastic Structures by the Limiting States Methods). Progress Report by Bauakademie der DDR, Berlin 1971, Part A.
Opitz, H.—Die Bemessung von GUP-Baukonstruktionen nach der Methode der Grenzzustände (Dimensioning of Building Structures of Fibreglass-Reinforced Unsaturated Polyester Resin by the Limiting States Method). Plaste und Kautschuk, Berlin 19 (1972) No. 11, pp. 827–829.
Opitz, H.—Ausarbeitung von Vorschlägen zu Bemessungs-richtlinien für Baukonstruktionen aus glasfaserverstärkten Kunststoffen nach der Methode der Grenzzustände (Preparation of Proposals to Draft a Code of Practice by which to Dimension by the Limiting States Method Building Structures of Fibreglass-Reinforced Plastics). Progress Report, Part 3, TU Dresden, WG Baustoffwissenschaft, 1972.
Keller, R.—Bestimmung der für die Ermittlung von Grenzzuständen bei GFP zugrunde zu legenden Material-kenngrössen und deren Abhangigkeit von Zeit, Temperatur und anderen Einflussgrössen (Determination of Material Indices as a Basis on which to Establish Limiting States of Fibreglass-Reinforced Polyester Resin and Dependence of such Variables on Time, Temperature, and other Factors). Progress Report, Part 2, TU Dresden, WG Baustoffwissenschaft, 1972.
Dahl, J., Beyer, O.W., Risse, J.—Strength of Materials and Dependability of Structures. Building Research Series, Riehe TORG, No. 51, Bauinformation, Berlin 1972.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Hütter, A., Opitz, H. Determination of factors relating to materials calculation in the limit state method for its application to plastic material-structures. Mat. Constr. 7, 139–143 (1974). https://doi.org/10.1007/BF02473913
Published:
Issue Date:
DOI: https://doi.org/10.1007/BF02473913