Abstract
In the present report the research work carried out and the experimental results obtained at ENEL-CRIS* and ISMES† laboratories are reported in order to illustrate the apparatus and techniques involved in multiaxial tests on cylindrical specimens. All specimens were cylindrical, diameter 160 mm, height 320 mm. Tests were carried out in two triaxial chambers: (i) a compression-compression triaxial chamber (C−C), suitable for the independent application of a lateral confining pressure, as well as of an axial compression load; and (ii) a compression-tension triaxial chamber (C-T), suitable for the independent application of a lateral confining pressure, as well as a direct axial tension load.
Similar content being viewed by others
References
Bellotti, R. and Rossi, P., ‘New prospects for evaluating the degree of safety in concrete structures subjected to multiaxial stresses’, Proceedings of IABSE-AIPC-IVBH Seminar on Concrete Structures Subjected to Triaxial Stresses, Bergamo, Italy, 1974, paper III-5 (AIPC Publishers, Zurich, 1975).
Gerstle, K. H.et al., ‘Strength of concrete under multiaxial stress states’, in Douglas McHenry International Symposium on Concrete and Concrete Structures, Publication Sp 55-5 (American Concrete Institute, Detroit, 1978) pp. 103–131.
Gerstle, K. H.et al., ‘Behaviour of concrete under multiaxial stress states’,J. Engng Mech. Div., Proc. ASCE 106 (EM 6) (1980) 1383–1403.
Ferrara, G., Rossi, P., Rossi, P. P. and Ruggeri, L., Dispositivi di prova per l'analisi sperimentale del comportamento di conglomerati cementizi sottoposti a stati triassiali di sollecitazione’, Atti del IV Convegno Nazionale AIAS, Roma, Italy, pp. 501–511 (ESA, Rome, 1976).
Bellotti, R. and Ronzoni, E., ‘Results of tests carried out on cylindrical concrete specimens subjected to complex stress states: a critical analysis’, Proceedings of International Conference on Concrete under Multiaxial Condition, RILEM, Toulouse, Vol. 1, pp. 53–74 (Presses de l'Université Paul Sabatier, Toulouse, 1984).
Author information
Authors and Affiliations
Additional information
ENEL-CRIS: Italian National Electricity Board, Hydraulic and Structural Research Center, Via Ornato, 90/14 Milan, Italy.
ISMES: Experimental Institute for Models and Structures, Viale G. Cesare, 29 Bergamo, Italy.
Rights and permissions
About this article
Cite this article
Bellotti, R., Rossi, P. Cylinder tests: experimental technique and results. Materials and Structures 24, 45–51 (1991). https://doi.org/10.1007/BF02472681
Published:
Issue Date:
DOI: https://doi.org/10.1007/BF02472681