Advertisement

Chemical and Petroleum Engineering

, Volume 33, Issue 6, pp 711–712 | Cite as

Application of high-temperature vacuum-brazing for fabrication of compact shell-and-tube heat exchanger

  • V. N. Radzievskii
  • V. A. Myshenko
  • G. G. Tkachenko
Technology

Keywords

Welding Heat Exchanger Tube Bank Joint Metal Tube Plate 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.

References

  1. 1.
    B. Ya. Mazurovskii, Electropulse Pressing of Tubes in Tube Plates of Heat Exchangers [in Russian], Naukova Dumka, Kiev (1980).Google Scholar
  2. 2.
    V. N. Radzievskii and G. G. Tkachenko, “Special features of evacuation of evacuation of wide brazing gap with powdered metal filler,” Svaroch. Proizvod., No. 1, 14–16 (1992).Google Scholar
  3. 3.
    V. N. Radzievskii and Yu. F. Gartsunov, “Gas evolution from iron powders as a wide gap is brazed in the process of heating under vacuum,” Svaroch. Proizvod., No. 12, 15–17 (1991).Google Scholar
  4. 4.
    V. N. Radzievskii, V. L. Dudchenko, and G. G. Tkachenko, “High-temperature brazing of steel with a wide gap”, Svaroch. Proizvod., No. 10, 7–10 (1991).Google Scholar

Copyright information

© Plenum Publishing Corporation 1998

Authors and Affiliations

  • V. N. Radzievskii
  • V. A. Myshenko
  • G. G. Tkachenko

There are no affiliations available

Personalised recommendations