Skip to main content
Log in

Reactions at the interface La0.5Ca0.5MnO3-YSZ/Al2O3 under anodic current

  • Published:
Ionics Aims and scope Submit manuscript

Abstract

The reaction at the interface of a solid electrolyte cell between air electrode (La0.5Ca0.5MnO3) and YSZ-electrolyte with different Al2O3-contents was investigated by electron microscopy (SEM) and x-ray diffraction (XRD). Formation of MnAl2O4 was detected in a 5 µm diffusion zone within the electrolyte. MnAl2O4 formation can be explained by diffusion of Mn-ions into the electrolyte and subsequent reaction with the α-Al2O3 grains during sintering. Cell performance and long-term stability in SOFC operation are not negatively affected by MnAl2O4 formation. However a rise in electrode resistance and slow delamination of perovskite oxide electrode were observed after some hours of electrolysis. This reaction is the consequence of oxygen gas pressure at the electrolyte in the MnAl2O4 diffusion zone. It is caused by local increase of electronic conductivity by MnAl2O4 formation. Long-term stability also for electrolysis conditions has been achieved by an additional intermediate YSZ-layer between air electrode and electrolyte.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

6. References

  1. D. Stolten, W. Schafer, Oxidkerarnische Brennstoffzelle, Handbuch der Keramik, Kapitel 8.5.2.1, Elektronik und Elektrotechnik, editor J. Kriegesmann, Deutscher Wirtschaftsdienst, April 1994.

  2. M. Kurbjuhn, W. Schäfer, D. Stolten, “Production of Zirconia Based Electrochernical Cells by Tape Casting and Screen Printing”, in Euroceramics II, Vol. 3; Editors: G. Ziegler, H. Hausner, pp. 2137–2147, Köln 1991.

  3. W. Schäfer, H. Geier, G. Lindemann, D. Stolten, “Electrolytes and Electrodes for Solid Oxide Fuel Cells with Improved Long-Term Stability”, 14th Risø Int. Symp. on Mat. Sci., Sept. 6–10, 1993, Roskilde, Denmark.

  4. M. Fandel, J. Höschele, W. Schäfer, R. Schmidberger, “Properties of Ca-doped LaMnO3”, Euroceramics I, Vol. 2, Editors: G. de With, R. A. Terpstra, R. Metselaar, pp 2236–2240, Elsevier, London 1989.

    Google Scholar 

  5. D. Stolten, E. Monreal, W. Schäfer, “Soft Glass Ceramic Sealing for gastight SOFC stacks”, 1st Europ. Conf. on SOFC, Oct. 3–7, 1994, Lucerne/Switzerland.

  6. H. Yokokawa, N. Sakai, T. Kawada and M. Dokiya, “Chemical Thermodynamic Stabilities of the Interface”, Science and Technology of Zirconia V, editors: S. P. S. Badwal, M. J. Bannister, R. H. J. Hannink, Tenomic Publishing CO, Inc., Lancaster, Pennsylvannia, USA 1993, p. 752–763.

    Google Scholar 

  7. H. Yokokawa, T. Horita, N. Sakai, T. Kawada, M. Dokiya, “Thermodynamic Considerations on plausible effect of oxygen flow on morphology of reaction products at the YSZ/Lanthanum Manganite Interface in Solid Oxide Fuel cells”, First European Solid Oxide Fuel Cell Forum, editor: U. Bossel, Lucerne, Switzerland, 3–7 Oct. 1994, p. 425–434.

  8. O. Yamamoto, Y. Takeda, R. Kanno, T. Kojima, “Stability of perovskite oxide electrode with stabilized zirconia”, J. Electrochem. Soc.89, 242 (1989).

    Google Scholar 

  9. D. M. Tricker, W. M. Stobbs, “Microstructural aspects of Lanthanum Zirconate formation”, in “High Temperature Electrochemical Behaviour of Fast Ion and Mixed Conductors”, Risø International Laboratory, Roskilde, 1993, p. 453–460.

    Google Scholar 

  10. H. Yokokawa, N. Sakai, T. Kawada, M. Dokiya, Solid State Ionics40/41, 398 (1990.

    Article  Google Scholar 

  11. J. Van Herle, K. Ravindranathan Thampi, ”A remark on the use of a reference electrode in SOFC testing”, in Advanced Fuel Cells Programme, Annex TI, Modelling and evaluation of advanced solid oxide fuel cells, Instrumentation & in-situ Diagnostics B5 Activity Meeting, IEA task report, Chexbres, 16–17 June 1993, p. 62–67.

  12. A. Yamashita, H. Tsukuda, T. Hashimoto, “Anodic and cathodic electrode reaction at La1−xSrxMnO3”, First European Solid Oxide Fuell Cell Forum, Editor: U. Bossel, 3–7 October, Lucerne, Switzerland 1994, p. 661–669.

  13. A. Kaiser, D. Stolten, “Sol-Gel-Beschichtungen fur SOFC-Electrolyte”, DKG-Jahrestagung 1995, to be published in “Handbuch der technischen Keramik”.

  14. M. Shane, M. L. Mecartney, “Sol-Gel synthesis of zirconia barrier coatings”, J. Mat. Sci.25, 1537 (1990).

    Article  CAS  Google Scholar 

  15. D. Stolten, E. Monreal, W. Schäfer, “Mechanical, Electrical Properties and Microstructure of Long-Term Stable SOFC Membranes”, 1994 Fuel Cell Seminar Abstracts, pp. 303–306, San Diego, California, USA.

  16. A. V. Vikar, J. Am. Ceram. Soc.73, 3382 (1990).

    Google Scholar 

  17. N.V. Suntsov, A.G. Miloslavsku, L. L. Zhuravlev, “Electrical properties of single crystals of aluminate spinels doped with sulfur”, Inorg. Mater.20, 396 (1984).

    Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Rights and permissions

Reprints and permissions

About this article

Cite this article

Kaiser, A., Monreal, E., Koch, A. et al. Reactions at the interface La0.5Ca0.5MnO3-YSZ/Al2O3 under anodic current. Ionics 2, 184–189 (1996). https://doi.org/10.1007/BF02376019

Download citation

  • Received:

  • Issue Date:

  • DOI: https://doi.org/10.1007/BF02376019

Keywords

Navigation