Skip to main content
SpringerLink
Log in

Photothermoelastic study of stress concentrations in a plate with internal heating

Values are found for the thermal-stress concentrations at a step change in the thickness of a plate subjected to internal heating

  • Published:
Experimental Mechanics Aims and scope Submit manuscript

Abstract

This paper describes a photothermoelastic method for simulating, in a three-dimensional model, the temperature gradients that occur in structural parts subjected to internal heating such as is frequently encountered in certain areas of nuclear-reactor design.

The method is applied to a plate which has a step change in thickness and sustains a nonlinear temperature gradient through its thickness. The shapes of the gradients simulate internal heating of the plate material. The values for the highest stresses on the free surfaces of the plate, within the thickness of the plate, and at the root of the step are presented in graphical form for a range of internal heat-generated conditions. Thermal-stress-concentration factors are presented for a step change in the thickness of a plate under this type of heating. Its design significance is discussed.

The same stress and stress-concentration values are shown to also apply to nonnuclear problems. During shut-down in conventional thermal plants, when the walls sustain linear steady-state temperature drops across their thicknesses, temperature profiles exactly analogous to those presented in this paper occur. The stresses can then be computed from the values presented here.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

  1. Weibel, E. E., “Thermal Stresses in Cylinders by the Photoelastic Method,” Proc. 5th Int. Cong. Appl. Mech., Cambridge, Mass., 213–220 (1938).

  2. Gerard, G., et al., “Progress in Photothermoelasticity,”Int. Symposium on Photoelasticity, M. Frocht, Ed., Pergamon Press, New York (1963).

    Google Scholar 

  3. Durelli, A. J. andRiley, W. F., Introduction to Photomemechanics, Prentice-Hall, Inc., Englewood Cliffs, N. J. (1965).

    Google Scholar 

  4. Leven, M. M. andJohnson, R. L., “Thermal Stresses on the Surface of Tube-sheet Plates at 10 and 33-1/3 Percent Ligament Efficiency,”Experimental Mechanics,4 (12),356–365 (1964).

    Article  Google Scholar 

  5. Slot, T., “Photoelastic Simulation of Thermal Stresses by Mechanical Prestraining,”Experimental Mechanics,5 (9)273–282 (1965).

    Article  Google Scholar 

  6. Becker, H., “An Exploratory Study of Stress Concentrations in Thermal Shock Fields,”J. Eng. for Industry (ASME Ser. B),84,343–348 (1962).

    Google Scholar 

  7. Gurtman, G. A. andColao, A. A., “Photothermoelastic Investigation of Stresses Around a Hole in a Plate Subjected to Thermal Shcok,”Experimental Mechanics,5 (4),97–104 (1965).

    Google Scholar 

  8. Haines, D. J. andWright, G. P., “An Experimental Method of Determining Thermal Strains,”Experimental Mechanics,9 (7),327–331 (1969).

    Article  Google Scholar 

  9. Blejwas, T. E., Lauffer, W. D. andTauchert, T. R., “Photothermoelastic Investigation of Stresses in a Composite Model,”Experimental Mechanics,9 (10),478–480 (1969).

    Google Scholar 

  10. Emery, A. F., Williams, J. A. andAvery, J., “Thermal-Stress Concentration Caused by Structural Discontinuities,”Experimental Mechanics,9 (12),558–564 (1969).

    Google Scholar 

  11. Emery, A. F., Barrett, C. F. andKobayashi, A. S., “Temperature Distributions and Thermal Stresses in a Partially Filled Annulus,”Experimental Mechanics,6 (12),602–608 (1966).

    Article  Google Scholar 

  12. Rothstein, R. J. andKirkwood, W. F., “Photothermoelastic Analysis of Stresses in Multiconnected Flat Circular Rings,”Experimental Mechanics,4, (8),237–243 (1964).

    Google Scholar 

  13. Burger, C. P., “A Generalized Method for Photoelastic Studies of Transient Thermal Stresses,”Experimental Mechanics,9 (12),529–537 (1969).

    Google Scholar 

  14. Burger, C. P., “Photoelastic Study of Thermal Stress Concentration in a Plate with a Small Change in Thickness,” Developments in Mechanics,5,1969. Proc. 11th MidWestern Mechanics Conference, Iowa State University Press, Ames, 1969.

  15. The Franklin Institute Research Laboratories, Thermal Stress Techniques in the Nuclear Industry, Elsevier Publishing Co., New York (1965).

    Google Scholar 

  16. Hovanesian, J. D. andKowalski, H. C., “Similarity in Thermoelasticity,”Experimental Mechanics,7 (2),82–84 (1967).

    Article  Google Scholar 

  17. Manson, S. S., Thermal Stress and Low-Cycle Fatigue, McGraw-Hill Book Co., New York (1966).

    Google Scholar 

Download references

Author information

Authors and Affiliations

  1. Dept. of Engineering Mechanics and Engineering Research Institute, Iowa State University, 50010, Ames, Iowa

    Christian P. Burger (Associate Professor)

Authors
  1. Christian P. Burger
    View author publications

    You can also search for this author in PubMed Google Scholar

Rights and permissions

Reprints and permissions

About this article

Cite this article

Burger, C.P. Photothermoelastic study of stress concentrations in a plate with internal heating. Experimental Mechanics 12, 483–488 (1972). https://doi.org/10.1007/BF02328822

Download citation

  • Received:

  • Revised:

  • Issue Date:

  • DOI: https://doi.org/10.1007/BF02328822

Keywords

Search

Navigation