Abstract
A numerical scheme is presented to correct heat release rate measurements made with the Ohio State University rate of heat release apparatus for the effects of inherent time delays in the measurement system.
Similar content being viewed by others
References
Chamberlain, D. L., “Rate of Heat Release — Tool for the Evaluation of the Fire Performance of Materials,” paper presented at a joint meeting of the Central States and Western States Sections of the Combustion Institute, San Antonio, Texas, April 21–22, 1975.
Draft of a proposed ASTM Test Method ASTM E5.02.30, “Test Method for Heat and Smoke Release Rates,” February 6, 1976.
Smith, E. E., “Heat Release Rate of Building Materials,”Ignition, Heat Release, and Noncombustibility of Materials, ASTM STP 502; American Society for Testing and Materials, 1972, pp. 119–134.
Smith, E. E., and Heibel, J. T., “Evaluating Performance of Cellular Plastics in Fire Systems,” Final Report PRC Project RP-75-1-36, 1977, Part II, pp. 18-27.
Praul, S. H., and Hmurick, L. V., “Instantaneous Temperature Measurements,”Review of Scientific Instruments, Vol. 44, No. 9 (September 1973), pp. 1363–1364.
Author information
Authors and Affiliations
Additional information
Note: Dr. Evans was a National Research Council Postdoctoral Research Associate at the National Bureau of Standards at the time this work was completed.
Rights and permissions
About this article
Cite this article
Evans, D.D., Breden, L.H. Time delay correction for heat release rate data. Fire Technol 14, 85–96 (1978). https://doi.org/10.1007/BF02308904
Issue Date:
DOI: https://doi.org/10.1007/BF02308904