Zusammenfassung
Trotz vieler Fortschritte auf dem Gebiet der Säure-Ätz-Technik sind wesentliche Probleme bisher nicht gelöst worden. Die Hauptaspekte dieses Problemkreises sind das nicht vorhersagbare Ätzmuster, die unkontrollierbare Langzeittiefenwirkung sowie die Entstehung von Schmelzausrissen aufgrund einer nicht definierbaren Bruchfläche bei Bracketabnahme. Ziel der vorliegenden Studie ist es, morphologische Ergebnisse der Schmelzkonditionierung bei Verwendung eines gepulsten Kryptonfluorid-Excimerlasers (248 nm) vorzustellen. Die rasterelektronenmikroskopische Untersuchung zeigte ein dem peripheren Säure-Ätz-Tup ähnelndes Oberflächenrelief. Zeichen einer Hitzeentwicklung wurden nicht gefunden. Die Anforderungen an ein modernes Lasersystem, das zu einer möglichen Alternative der konventionellen Säure-Ätz-Technik werden könnte, werden diskutiert.
Summary
Although there have been many advances in the field of acid etching, major problems still present. For the most part, these are the unpredictability of the effects of etching, the lack of control of the depth of etching over the long term, and the development of enamel fractures occurring on debonding. The aim of this study was to investigate the morphological effects of enamel conditioning using a pulsed krypton fluoride excimer laser (wavelength 248 nm). Scanning electron microscopic examination revealed a surface similar to that produced by peripheral etching; no signs of thermal damage were to be seen. The requirements that have to be met by a modern laser considered as a possible alternative to conventional acid etching, are discussed.
Literatur
Abendroth, R., K. Bößmann: Variation der Ätzmuster an Schmelzoberflächen nach Behandlung mit verschiedenen Ätzmitteln. Dtsch. zahnärztl. Z. 34 (1979), 181–184.
Buonocore, M. G.: A simple method of increasing the adhesion of acrylic filling materials to enamel surfaces. J. dent. Res. 1955 (34), 849–853.
Dennison, J. B., R. G. Craig: Characterization of enamel surfaces prepared with commerical and experimental etchants. J. Amer. dent. Ass. 97 (1978), 799–805.
Diedrich, P.: Enamel alterations from bracket bonding and debonding: A study with the scanning electron microscope. Amer. J. Orthodont. 79 (1981), 500–522.
Ferreira, J. M., J. Palamara, P. P. Phakey: Effects of continuous-wave CO2 laser on the ultrastructure of human dental enamel. Arch. oral. Biol. 34 (1989), 551–562.
Frentzen, M., H. J. Koort, O. Kermani, M. U. Dardenne: Bearbeitung von Zahnhartsubstanzoberflächen mit einem 193 nm ArF-Excimer-Laser. Dtsch. zahnärztl. Z. 44 (1989), 454–457.
Goldman, L., J. A. Gray, J. Goldman, B. Goldman, R. Meyer: Effect of laser beam impacts on teeth. J. Amer. dent. Ass. 70 (1965), 601–606.
Goodman, B. D., A. J. Gwinnett: A comparison of laser-and acid-etched human enamel using scanning electron microscopy. Arch. oral Biol. 22 (1977), 215–220.
Liberman, R., T. H. Segal, D. Nordenberg, L. I. Serebro: Adhesion of composite materials to enamel: Comparison between the use of acid and lasing as pretreatment. Lasers Surg. Med. 4 (1984), 323–327.
Liesenhoff, T., T. Bende, H. Lenz, T. Seiler: Abtragen von Zahnhartsubstanzen mit Excimer-Laserstrahlen. Dtsch. zahnärztl. Z. 44 (1989), 426–430.
Munechika, T.: A comparison of tensile bond strength of composite resins to longitudinal and transverse sections of enamel prisms in human teeth. J. dent. Res. 63 (1984), 1079–1082.
Nagasawa, A.: Technical development in application of lasers to dentistry. In: Yamamoto, H., K. Atsumi, H. Kusakari (eds.): Lasers in dentistry. Proc. of the International Congress of Laser in Dentistry, Tokyo, Japan, 5–6 August 1988. Excerpta Medica, Amsterdam-New York-Oxford 1989, p. 73–84.
Nelson, D. G. A., J. S. Wefel, W. L. Jongebloed, J. D. B. Featherstone: Morphology, histology and crystallography of human dental enamel treated with pulsed low-energy infrared laser radiation. Caries Res. 21 (1987), 411–426.
Newesely, H.: Zur Noxe durch den Ätzvorgang mit Säuren bei der Schmelzversiegelung. Dtsch. zahnärztl. Z. 30 (1975), 508–512.
Reinhardt, K. J., J. Vahl: Ein rasterelektronenmikroskopischer nachweis der Eindringtiefe von Schmelzadhäsiven in geätztem Zahnschmelz. Dtsch. zahnärztl. Z. 34 (1979), 403–405.
Retief, D. H.: Effect of conditioning the enamel surface with phosphoric acid. J. dent. Res. 52 (1973), 333–341.
Sato, K., Y. Kohsaka, S. Fujisaka, S. Ochiai, H. Yamamoto: Effects of excimer laser irradiation on bone. In: Yamamoto, H., K. Atsumi, H. Kusakari (eds.): Lasers in dentistry. Proc. of the International Congress of Laser in Dentistry, Tokyo, Japan, 5–6 August 1988. Excerpta Medica, Amsterdam-New York-Oxford 1989, p. 99–104.
Silverstone, L. M.: The acid etch technique: in vitro studies with special reference to the enamel surface and enamel-resin interface. In: Silverstone, L. M., I. L. Dogan (eds.): Proc. of an international symposium on the acid etch technique, North Central, St. Paul 1975, p. 13–39.
Smith, R. S., J. A. Spinelli, D. J. Tartakow: Phosphoric acid penetration during direct bonding. Amer. J. Orthodont. 70 (1976), 543–550.
Srinivasan, R., W. J. Leigh: Ablative photodecomposition: Action of far ultraviolet (193 nm) radiation on poly (ethylene terephthalate) film. J. Amer. Chem. Soc. 104 (1982), 6784.
Tagomori, S., T. Moriaka: Combined effects of laser and fluoride on acid resistance of human dental enamel. Caries Res. 23 (1989), 225–231.
Vahl, J., U. Wosiewitz: Feinreliefstudien konditionierter Schmelzflächen und ihrer Adhäsiv-Matrizen bei der Zahnschmelzversiegelung. Dtsch. zahnärztl. Z. 31 (1976), 35–46.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Ruppenthal, T., Stratmann, U., Schürenberg, M. et al. Morphologische Ergebnisse zur Anwendbarkeit eines gepulsten Kryptonfluorid-Excimerlasers im Rahmen der Schmelzkonditionierung. Fortschritte der Kieferorthopädie 52, 315–321 (1991). https://doi.org/10.1007/BF02166628
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF02166628