Skip to main content
Log in

Oxidative stability of lubricants for dry circuit sliding contacts

  • Published:
Journal of thermal analysis Aims and scope Submit manuscript

Abstract

The thin film oxidation resistance of isoparaffin and two polyol esters synthetic lubricants was studied by high pressure differential scanning calorimetry. The oxidation induction time of each lubricant was measured by isothermally heating the sample in an oxygen environment. Arrhenius plots were constructed to predict the service life of the lubricant at low temperatures. The results indicate that polyol esters exhibit better oxidative stability than isoparaffins.

Zusammenfassung

Mittels Hochdruck-Differential-Scanning-Kalorimetrie wurde die Dünnschicht-Oxydationswiderstandsfestigkeit von Isoparaffin- und zwei synthetischen Polyolesterschmiermitteln untersucht. Die Oxydationsinduktionszeit jedes Schmiermittels wurde durch isothermes Erhitzen der Probe in Sauerstoff gemessen. Zur Vorhersage der Lebensdauer der Schmiermittel bei niedrigen Temperaturen wurden die entsprechenden Arrhenius-Diagramme erstellt. Die Ergebnisse zeigen, dass Polyolester über eine bessere oxydative Stabilität verfügen als Isoparaffine.

Резюме

Методом дифференциа льной сканирующей калориметрии высоко го давления изучена устойчивост ь к окислению тонких п ленок изопарафина и двух сл ожных эфиров полиспирта, как синте тических смазок. Инду кционное время окисления кажд ой смазки было измерено путем изоте рмического нагрева о бразца в атмосфере кислорода. Для установления срока службы каждой с мазки при низких темп ературах были построены аррен иусовские графики. Результаты п оказали, что сложные з фиры полиспиртов более ус тойчивы и окислению, чем изопарафины.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

  1. R. V. Steenstrup, V. M. Fiacco and L. K. Schultz, Proceedings of the Twenty-Eighth Annual Holm Conference on Electrical Contacts, 1982 p 59– 68.

  2. J. P. Coates and L. C. Setti, ASLE Trans., 29 (3) (1985) 394.

    Google Scholar 

  3. J. R. Barcelo and C. Otero, J. Inst. Pet., 50 (1964) 15.

    Google Scholar 

  4. A. Zeman, R. Stuwe and K. Koch, Thermochim. Acta, 80 (1984) 1.

    Article  Google Scholar 

  5. E. Dimiroff, J. V. Moffitt and R. D. Quillian, ASME Trans., J. Lubr. Techn., (1969) 406.

  6. D. T. Rogers, W. W. Rice and F. L. Jonach, SAE Trans., 64 (1956) 782.

    Google Scholar 

  7. J. F. Ford, J. Inst. Pet., 54 (1967) 198.

    Google Scholar 

  8. J. A. Walker and W. Tsang, Nat. Bur. Stand. (U.S.), Spec. Publ., 584 (1980) 271.

    Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Rights and permissions

Reprints and permissions

About this article

Cite this article

Papathomas, K.I., Katnani, A.D. Oxidative stability of lubricants for dry circuit sliding contacts. Journal of Thermal Analysis 35, 153–161 (1989). https://doi.org/10.1007/BF01914275

Download citation

  • Received:

  • Revised:

  • Issue Date:

  • DOI: https://doi.org/10.1007/BF01914275

Keywords

Navigation