Abstract
In a radial flow pump operating in off-design conditions, regions of stall can exist on the rotating impeller blade and on the downstream diffuser blade, vane or tongue. Interaction of these stall zones can generate complex patterns of vorticity concentrations. In turn, these vorticity concentrations are related to sources of unsteady stagnation enthalpy. The form of these patterns is strongly dependent on the instantaneous location of the impeller trailing-edge relative to the leading-edge of the vane.
Comparison of instantaneous with ensemble-averaged images shows that the flow structure in the gap region between the impeller and the vane is highly repetitive. Away from this region, in particular in the separated shear layer from the vane, the nonrepetitive nature of the vorticity field is manifested in substantial reduction of peak levels of vorticity in the ensemble-averaged image, relative to the instantaneous image.
The three-dimensional flow structure resulting from these separation zone interactions was characterized via end views of the flow patterns. Particularly pronounced concentrations of vorticity can occur in this plane. They tend to be located in the shear layer at the outer edge of the large-scale separation zone. These vorticity concentrations are, however, highly non-stationary for successive passages of the impeller blade. Ensemble-averaging reveals that they persist primarily on the endwalls of the diffuser.
Similar content being viewed by others
References
Akin O (1991) Unsteady flow in an actively-controlled centrifugal pump. M.S. Thesis, Dept. Mechanical Engineering and Mechanics, Lehigh University, Bethlehem, PA 18015
Akin O; Rockwell D (1994a) Actively-controlled radial flow pumping system: manipulation of spectral content of wakes and wake-blade interactions (in press). J Fluids Eng
Akin O; Rockwell D (1994b) Flow structure in a radial flow pumping system using high-image-density particle image velocimetry (in press). J Fluids Eng
Arndt N;Acosta AJ;Brennen CE;Caughey TK (1989) Rotor-stator interaction in a diffuser pump. J Turbomachinery 111: 213–221
Arndt N;Acosta AJ;Brennen CE;Caughey TK (1990) Experimental investigation of rotor-stator interaction in a centrifugal pump with several vaned diffusers. J Turbomachinery 112: 98–108
Dong R;Chu S;Katz J (1992a) Quantitative visualization of the flow within the volute of a centrifugal pump. Part A: technique. J Fluids Eng 114: 390–395
Dong R;Chu S;Katz J (1992b) Quantitative visualization of the flow within the volute of a centrifugal pump. Part B: results and analysis. J Fluids Eng 114: 396–403
Gursul I;Rockwell D (1990) Vortex street impinging upon an elliptical leading-edge. Fluid Mech 211: 211–242
Neise W (1976) Noise reduction and centrifugal fans: a literature survey. Sound and Vibration 45: 375–403
Neise W (1982) Review of noise reduction methods for centrifugal fans. Engineering for Industry 104: 151–161
Rockwell D (1983) Invited lecture: oscillations of impinging layers. AIAA J 21: 645–664
Rockwell D;Magness C;Towfighi J;Akin O;Corcoran T (1993) High-image-density particle image velocimetry using laser scanning techniques. Exp Fluids 14: 181–192
Simpson HC;Clark TA;Weir GA (1967) A theoretical investigation of hydraulic noise in pumps. J Sound and Vibration 5: 456–488
Takmaz L; Rockwell D (1994) Unsteady flow structure and surface pressure due to translation of a cylinder past an elliptical leading-edge (in press). J Fluids and Structures
Author information
Authors and Affiliations
Additional information
The authors are grateful to the Office of Naval Research for support of this research program
Rights and permissions
About this article
Cite this article
Akin, O., Rockwell, D. Interaction of zones of flow separation in a centrifugal impeller-stationary vane system. Experiments in Fluids 17, 427–433 (1994). https://doi.org/10.1007/BF01877045
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF01877045