Abstract
The simple “composite” model of material with inhomogeneous dislocation structure is extended to provide information on strain response to stress changes in steady-state creep. This extension enables us, therefore, to simulate the so-called dip-test technique and to calculate operationally defined internal stress. It is shown that this internal stress corresponds to the back stress acting in soft regions. The model is also convenient for the calculation of strain transients.
Similar content being viewed by others
References
Nix W. D., Ilschner B.:in Proc. 5th Int. Conf. on the Strength of Metals and Alloys (eds. Haasen P., Gerold V., Kostorz G.). Pergamon Press, Oxford, 1980, Vol. 3, p. 1503.
Nix W. D., Gibeling J. C., Fuchs K. P.:in Mechanical Testing for Deformation Model Development, ASTM STP 765 (eds. Rohde R. W., Swearengen J. C). American Society for Testing and Materials, 1982, p. 301.
Mughrabi H.: Acta Metall.31 (1983) 1367.
Frost H. J., Ashby M. F.: Deformation-Mechanism Maps. Pergamon Press, Oxford, 1982, p. 21.
Ahlquist C. N., Nix W. D.: Scr. Metall.3 (1969) 679.
Ahlquist C. N., Nix W. D.: Acta Metall.19 (1971) 373.
Tobolová Z., Čadek J.: Philos. Mag.26 (1972) 1419.
Toma K., Yoshinaga H., Morozumi S.: Trans. Jap. Inst. Met.17 (1976) 102.
Evans R. W., Roach W. J. F., Wilshire B.: Scr. Metall.19 (1985) 999.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Dobeš, F. Internal stresses in the model of hard and soft regions. Czech J Phys 38, 524–526 (1988). https://doi.org/10.1007/BF01597468
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF01597468