Abstract
An experimental investigation is made to study the flow characteristics of slot jet impingement on a cylinder. The velocity profiles and pressure distribution around the cylinder are reported for various parameters namely, the flow rate, width of the nozzle, distance of the cylinder from the jet exit and eccentricity of the cylinder to the jet axis.
Zusammenfassung
Es wurde eine experimentelle Untersuchung gemacht, um die Strömungseigenschaften eines Düsenstrahls zu unterschen, der auf einen Zylinder prallt. Die Geschwindigkeitsprofile und die Druckverteilungen an dem Zylinder wurden für unterschiedliche Parameter dokumentiert. Die Parameter sind die Strömungsgeschwindigkeit, Düsengröße, Abstand zwischen Zylinder und Strahlaustritt und die Exzentrizität von Zylinder und Strahlachse.
Similar content being viewed by others
Abbreviations
- B :
-
breadth of the nozzle at the exit
- D :
-
diameter of the cylinder
- C p :
-
pressure coefficient
- g :
-
acceleration due to gravity
- L :
-
distance of the cylinder from jet exit
- P a :
-
atmospheric pressure
- P c :
-
static pressure along the jet center-line
- P 0 :
-
stagnation pressure
- P W :
-
wall static pressure
- Re D :
-
Reynolds numberu j D/ν a
- Re W :
-
Reynolds numberu j W/ν a
- r :
-
distance measured from cylinder surface in radial direction
- r m :
-
position of maximum velocity from cylinder surface
- r 0.5 :
-
half width of the jet
- u :
-
mean velocity
- u j :
-
mean velocity at the jet exit
- u m :
-
maximum velocity
- W :
-
width of the nozzle
- ϱ a :
-
density of air
- ϱ m :
-
density of mercury
- ϱ w :
-
density of water
- μ :
-
absolute viscosity
- ν :
-
kinematic viscosity
References
Schuh, H.; Persson, B.: Heat transfer on circular cylinders exposed to free-jet flow. Int. J. Heat Mass Transfer. 7 (1964) 1257–1272
Sutera, S. P.; Maeder, P. F.; Kestin, J.: On the sensitivity of heat transfer in the stagnation point bondary layer to free-stream vorticity. J. Fluid Mech. 16 (1963) 497–520
Igarashi, T.; Iida, Y.: Fluid flow and heat transfer around a circular cylinder with vortex generators.JSME Int. J. Series 11, 31 (1988) 701–708
Igarashi, T.: Fluid flow and heat transfer in separated region of a circular cylinder. Proc. ASME-JSME Thermal Engg. Joint Conf. 3 (1983) 87–95
Igarashi, T.: Characteristics of flow around a square Prism. Bull. JSME 27 (1984) 1858–1865
Igarashi, T.: Characteristics of the flow around rectangular cylinder. The case of the angle of attack 0 Degree. Bull. JSME 28 (1985) 1690–1696
Lachmann, G. V. (ed.): Boundary layer and flow control, I. London: Pergamon Press 1963
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Brahma, R.K., Faruque, O. & Arora, R.C. Experimental investigation of mean flow characteristics of slot jet impingement on a cylinder. Wärme- und Stoffübertragung 26, 257–263 (1991). https://doi.org/10.1007/BF01589996
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF01589996