Abstract
Calculations were made by the finite element method of the stressed and strained condition and strength of RPP-2 and RKS-3 cemented carbide inserts in relation to their orientation in cutting. The calculated fields of displacements, strains, and stresses from the action of the concentrated load applied to the tip of the angle of the cutting edges were obtained for different angles of orientation. At the same time the zones of dangerous tensile stresses were determined. The results of calculations for RPP-2 and RKS-3 cemented carbide inserts were analyzed. An evaluation is given of the influence of the design parameters of the inserts on their stressed and strained condition and strength. Recommendations are made for improving the design of the inserts and selection of the angle of fastening of them in the holder. The basic requirements for an optimum insert are formulated.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
Literature Cited
M. G. Krapivin, Mining Tools [in Russian], Nedra, Moscow (1979).
M. G. Loshak, The Strength and Life of Cemented Carbides [in Russian], Nauk. Dumka, Kiev (1984).
Additional information
The Institute of Problems of Strength, Academy of Sciences of the Ukrainian SSR, Kiev. Central Scientific-Research, Planning, and Design Institute for Entry Driving Machines and Units for the Coal and Mining Industry and Underground Construction, Moscow. Translated from Problemy Prochnosti, No. 12, pp. 53–56, December, 1989.
Rights and permissions
About this article
Cite this article
Gnuchii, Y.B., Khrapov, Y.G., Kostyunin, Y.A. et al. Stressed and strained condition and strength of the cemented carbide inserts of new types of rock-breaking cutters. Report 1. Strength Mater 21, 1677–1681 (1989). https://doi.org/10.1007/BF01533409
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF01533409