Skip to main content
Log in

Non-destructive quality test of adhesive joints by means of resonance measurements

  • Originalarbeiten
  • Published:
Kolloid-Zeitschrift Aims and scope Submit manuscript

Summary

  1. 1.

    The dynamic elastic modulus E′ and the loss factor tan δ of adhesive joints have been measured at a ultrasonic frequency of 50 kc/s by means of a coupled resonant bar method and the results of these resonance properties have been considered in their relation to those of the thickness b and the strength F of the joints.

    From the results it was found that E′ as well as tan δ are so intimately correlated with the bond strength F that a single E′−F or tan δ−F correlation curve, typical of the adherend material, is obtained, independently of the type of adhesive and of the condition of adhesion employed, so long as comparison is made of the resonance properties and F at a fixed joint thickness b for each of adherends used.

  2. 2.

    The results indicate the possibility that the resonant method for determining the resonance properties of an adhesive joint can be used as a nondestructive quality test of the joint.

  3. 3)

    The results obtained as regards E′−F and E'(F)−b relationships, and the effect upon them of adding some fillers has been qualitatively considered, taking into account the residual stresses and their distribution in the adhesive joint.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

  1. Dietz, A. G. H., J. Closman, G. M. Kavanaugh and N. J. Rossen, A.S.T.M. Proc. 50, 1414 (1950).

    CAS  Google Scholar 

  2. Nolle, A. W. and P. J. Westervelt, J. Appl. Phys. 21, 304 (1950).

    Article  CAS  Google Scholar 

  3. Zacharias, J., Phys. Rev. 44, 116 (1933).

    Article  Google Scholar 

  4. Siegel, S. and S. L. Quimby, Phys. Rev. 49, 663 (1936).

    Article  Google Scholar 

  5. Koehn, G. H., Adhesion and Adhesives, Fundamentals and Practice (Soc. Chem. Ind.) (New York 1954) 125.

    Google Scholar 

  6. Bartusch, W., Kunststoffe 40, 274 (1956); Bikerman, J. J., Surface Chemistry for Industrial Research (New York 1948), 361; Meissner, H. P. and G. H. Baldauf, Trans. Amer. Soc. Mech. Engrs. 73, 697 (1951); Kanamaru, K., Journ. Japan Soc. for Testing Materials 7, 441 (1958); Chem. and Ind. 11, 466 (1958).

    Google Scholar 

  7. Stephens, R. H. in: Stanford, E. G. and J. H. Fearon, Progress in Non-Destructive Testing, Vol. I (London 1958), 167.

  8. McBain, J. W. and W. B. Lee, J. Phys. Chem. 32, 1178 (1928); Proc. Roy. Soc. (London) A 113, 606 (1926).

    Article  CAS  Google Scholar 

  9. De Bruyne, N. A. and R. Houwink in: Adhesion and Adhesives (London, 1951), 91–121.

  10. Mylonas, C., Proc VIIth Intern. Congr. Appl. Mech. 4, 147 (London 1948).

    Google Scholar 

  11. Presented at the 12th Annual Meeting of the Chem. Soc. of Japan.

  12. Smekal, A., Handbuch der Physik 24II (Berlin 1933); Houwink, R. in: The Phenomena of Polymerization and Condensation (London 1935), 127.

Download references

Author information

Authors and Affiliations

Authors

Rights and permissions

Reprints and permissions

About this article

Cite this article

Kanamaru, K., Ikari, K., Kishimoto, T. et al. Non-destructive quality test of adhesive joints by means of resonance measurements. Kolloid-Zeitschrift 170, 123–131 (1960). https://doi.org/10.1007/BF01525171

Download citation

  • Received:

  • Issue Date:

  • DOI: https://doi.org/10.1007/BF01525171

Keywords

Navigation