This is a preview of subscription content, log in via an institution to check access.
References
M. Ruhle, N. Claussen, and A. H. Heuer, “Microstructural studies of Y2O3-containing tetragonal ZrO2 polycrystals (Y-TZP),” Adv. Ceramics,12, 352–370 (1984).
V. Gross and M. V. Swain, “Mechanical properties and microstructure of sintered and hot isostatically pressed yttria-partially-stabilized zirconia (Y-PSZ),” J. Aust. Ceram. Soc.,22, No. 1, 1–12 (1986).
G. S. A. M. Theunissen, J. S. Bouma, A. J. A. Winnubst, and A. J. Burggraaf, “Mechanical properties of ultra-fine grained zirconia ceramics,” J. Mater. Sci.,27, No. 16, 4429–4438 (1992).
G. S. A. M. Theunissen, A. J. A. Winnubst, and A. J. Burggraaf, “Surface and grain boundary analysis of doped zirconia ceramics studied by AES and XPS,” Ibid., 27, No. 18, 5057–5066 (1992).
G. S. A. M. Theunissen, A. J. A. Winnubst, and A. J. Burggraaf, “Segregation aspects in the ZrO2-Y2O3 ceramics system,” J. Mater. Sci. Lett.,8, No. 1, 55–57 (1989).
V. A. Dubok, M. 1. Kabanova, and N. P. Pavlenko, “Change in pore size during the sintering of different powders of partially stabilized zirconia,” Poroshk. Metall., No. 12, 18–23 (1988).
M. A. C. G. Van de Graaf, J. H. H. ter Maat, and F. J. Burggraaf, “Microstructure and sintering kinetics of highly reactive ZrO2-Y2O3 ceramics,” J. Mater. Sci.,20, No. 4, 1407–1418 (1985).
W. F. M. Groot-Zevert, A. J. A. Winnubst, G. S. A. M. Theunissen, et al., “Powder preparation and compaction behavior of fine-grained Y-TZP,” Ibid.,25, No. 8, 3449–3455 (1990).
A. Roosen and H. Hausner, “Low-temperature sintering of zirconia,” CFI/Ber. DLG, No. 4/5, 184–192 (1985).
M. I. Kabanova, Relationship Between the Physico-Chemical Properties of Powders and Zirconia-Based Ceramics. Author's Abstract of Chemical Sciences Candidate Dissertation, Kiev (1990).
M. I. Kabanova, V. A. Dubok, S. A. Nochevkin, et al., “Microstructure and porosity of compacts of zirconia powders obtained at pressures up to 6 GPa,“ Ibid., No. 9, 69–74 (1991).
M. I. Kabanova and V. A. Dubok, “Chemical and phase changes in the sintering of partially stabilized zirconia,” Ibid., No. 5, 85–89 (1992).
H. K. Schmid, “Quantitative analysis of polymorphic mixes of zirconia by x-ray diffraction,” J. Am. Ceram. Soc.,70, No. 5, 367–376 (1987).
M. L. McCartney, “Influence of an amorphous second phase on the properties of yttria-stabilized tetragonal zirconia polycrystals (Y-TZP),” Ibid., No. 1, 54–58.
M. V. Swain, “Limitation of maximum strength of zirconia-toughened ceramics by transformation toughening increment,” Ibid.,68, No. 4, 97–99 (1985).
A. G. Evans and R. M. Cannon, “Toughening of brittle solids by martensitic transformations (Overview No. 48)”, Acta. Metall.,34, 761–800 (1986).
P. Duran, P. Recio, J. R. Jurado, et al., “Y(Er)-doped tetragonal zirconia polycrystalline solid electrolyte. II. Microstructure and mechanical properties,” J. Mater. Sci.,24, 708–716 (1989).
M. I. Kabanova, V. A. Dubok, S. A. Nochevkin, et al., “Sintering and evolution of porosity in compacts obtained from powders of ZrO2(Y2O3) at a pressure of 6 GPa,” Poroshk. Metall., No. 2, 30–36 (1993).
T. Noma, A. B. Sawoaka, M. Yoshimura, et al., “Effect of high pressure treatment on the mechanical properties of Y-TZP,” J. Mater. Sci. Lett., No. 7, 212–214 (1988).
Additional information
Institute of Problems of Materials Science, National Academy of Sciences of the Ulcraine (Kiev). Translated from Poroshkovaya Metallurgiya, Nos. 1/2(383), pp. 103–109, January–February, 1996. Original article submitted March 15, 1994.
Rights and permissions
About this article
Cite this article
Kabanova, M.I., Dubok, V.A. Effect of the characteristics of the powders on the microstructure and mechanical properties of sintered ceramic ZrO2-3% (mol.) Y2O3 . Powder Metall Met Ceram 35, 92–97 (1996). https://doi.org/10.1007/BF01512673
Issue Date:
DOI: https://doi.org/10.1007/BF01512673