Skip to main content
Log in

Tests on dinas concrete blocks in soaking pits of a blooming mill

  • Refractories in Service
  • Published:
Refractories Aims and scope

Conclusions

Dinas brick in the lining of soakingpits at 1400 – 1450‡ showed the same resistance as dinas brick, to the separating wall under the refractory layer the dinas concrete did not fuse and after 8 months of service was still suitable for further use.

Temperature measurements show that the surface of the brickwork below the refractory lining heats up to 1200‡. This excludes the possibility of using heat-resistant concrete with a portland cement base and a chamotte filler in the brickwork of the basic walls of pits.

Dinas concrete blocks can be used to replace dinas brick in the working lining of soaking pits and chamotte in the

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

  1. G. G. Fel'dgandler. Information 4, Series 6, TsIIN ChM, Metallurgizdat, Moscow, 1960.

    Google Scholar 

  2. V. V. Shalayev. Metallurg, 1956, No. 8.

  3. N. P. D'yachkow and others. Ogneupory, 1961, No. 9.

Download references

Author information

Authors and Affiliations

Authors

Rights and permissions

Reprints and permissions

About this article

Cite this article

Shalayev, V.V., Burkser, V.Y., Borodin, P.P. et al. Tests on dinas concrete blocks in soaking pits of a blooming mill. Refractories 3, 202–207 (1962). https://doi.org/10.1007/BF01291688

Download citation

  • Issue Date:

  • DOI: https://doi.org/10.1007/BF01291688

Keywords

Navigation