Conclusions
Grinding of materials when mixed in edge-runner mixers is unimportant, because of speed differences across the width of the roll, compared with the rolling action exerted on the materials by the rolls.
The work done by different types of mixing machines can be compared by examining their mix process parameters, determined by the methods described.
The most important factors to be considered in evaluating the operation of mixers treating refractory materials are the specific compressive forces applied and the frequency with which the load is applied.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
Literature cited
N. S. Volosov, in: Scientific and Technical Information [in Russian], NIIStrommash, Leningrad (1961).
A. M. Lastovtsev, Trudy MIKhM., No. 7 (1950).
A. M. Lastovtsev and A. M. Khval'kov, Khimicheskoe Mashinostroenie, No. 1 (1959).
A. V. Chuvnilo, Advances in the Theory and Practice of Powdered Mix Preparation [in Russian], VNIIÉM (1964).
R. I. Ivakin, Liteinoe Proizvodstvo, No. 9, 32 (1965).
L. B. Levenson and G. I. Preigerzon, Grinding and Screening of Minerals [in Russian], Gostekhizdat (1940), p. 340.
I. I. Poroshin, Stroitel'nye i Dorozhnye Mashiny, No. 10, 27 (1964).
Ya. M. Pikovskii et al., Roadmaking Machines and Equipment [in Russian], Mashgiz (1960), p. 213, 214.
A. P. Larin, Ogneupory, No. 4, 158 (1957).
Author information
Authors and Affiliations
Additional information
Translated from Ogneupory, No. 9, pp. 18–22, September. 1968.
Rights and permissions
About this article
Cite this article
Makarov, V.I., Larin, A.P. Mode of action of refractory material mixers. Refractories 9, 549–553 (1968). https://doi.org/10.1007/BF01283499
Issue Date:
DOI: https://doi.org/10.1007/BF01283499