Abstract
As a model experiment for the corrosion behaviour of brazed joints in water pipes made of stainless steel, some tens ofμan broad joints made of three different brazes (Ag/Cu/In/Ni, Ag/Cu/Sn, Ag/Cu) were exposed to streaming water at different Cl− concentrations. The samples were polarized. The three-dimensional distribution of the corrosion products, obtained by Auger mapping and depth profiling, supplied some information about the corrosion behaviour of the joints.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
G. Herbsieb, W. Schwenk,Werkst, u. Korr. 1975,26, 93.
G. Herbsieb, W. Schwenk,Mannesmann Forschungsbericht 1004, Duisburg, 1985.
H.-D. Steffens, B. Wielage, W. Brandi, B. Röschenbleck,DVS-Ber. 1984,92, 92.
T. Takemoto, I. Okamoto,Welding Res. Suppl. 1984, 300s.
W. Brandi, H. Bubert, H. Hantsche, H. Jenett, H.-D. Steffens,Fresenius' Z. Anal. Chem. 1987 (in press).
W. Brandi,Dissertation, Dortmund, 1987.
U. Becker, H. Bubert,Spectrochim. Acta 1986,413, 859.
A. W. Czanderna (ed.),Methods of Surface Analysis, Elsevier, Amsterdam, 1975, p. 33.
L. E. Davis, N. C. MacDonald, P. W. Palmberg, G. E. Riach, R. E. Weber,Handbook of Auger Electron Spectroscopy, Physical Electronics Division, Perkin-Elmer Corporation, Eden Prairie, MN, 1978.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Jenett, H., Brandi, W., Bubert, H. et al. Investigation on the corrosion of brazed joints by means of scanning auger microprobe. Mikrochim Acta 91, 409–427 (1987). https://doi.org/10.1007/BF01199517
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF01199517