Abstract
A new equationE =E 0 (1 −bp)n has been derived semi-empirically to describe the porosity dependence of elastic properties of thermosetting polymers. The material constantb is defined as a “pore distribution geometry factor” and the other material constantn is dependent on pore geometry. The equation shows good agreement with the data on porous polyester and epoxy resins.
Similar content being viewed by others
References
Z. Hashin,J. Appl. Mech. 29 (1) (1962) 143.
Z. Hashin andS. Shtrikman,J. Mech. Phys. Solids 10 (1962) 343.
L. E. Nielsen, “Mechanical Properties of Polymers and Composites”, Vol. 2 (Marcel Dekker, New York, 1974) p. 407.
O. Ishai andL. J. Cohen,Int. J. Mech. Sci. 9 (1967) 539.
B. Paul,Trans. Amer. Inst. Mech. Eng. 218 (1960) 36.
J. K. Mackenzie,Proc. Phys. Soc. (London) 63B (1) (1950) 2.
R. L. Coble andW. D. Kingery,J. Amer. Ceram. Soc. 39 (1956) 377.
J. M. Whitney andR. L. McCullough, “Micro Models”, in “Composite Design Guide”, Vol. 2 (University of Delaware, 1980) p. 84.
F. P. Knudsen,J. Amer. Ceram. Soc. 42 (1959) 376.
D. Lewis III.,Amer. Ceram. Soc. Bull. 57 (1978) 434.
B. E. Read andG. D. Dean, “The Determination of Dynamic Properties of Polymers and Composites” (Hilger, Bristol, 1978) p. 94.
A. F. Johnson, “Engineering Design Properties of GRP” (The British Plastics Federation, Pub. No. 215/26–79) p. 12.
W. R. Manning, O. Hunter Jr andB. R. Powell Jr,J. Amer. Ceram. Soc. 52 (1969) 441.
D. R. H. Hasselman andR. M. Fulrath,ibid. 47 (1964) 52.
R. L. McCullough, “Micro-models for composite materials - Particulate and Discontinuous Fibre Composites”, in “Composite Design Guide”, Vol. 2 (University of Delaware, 1980) p. 64.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Phani, K.K., Mukerjee, R.N. Elastic properties of porous thermosetting polymers. J Mater Sci 22, 3453–3458 (1987). https://doi.org/10.1007/BF01161441
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF01161441