References
V. I. Dobatkin and V. I. Elagin, “Improvement of the set of properties and the quality of semifinished products from high-strength aluminum alloys,”Tekhnologiya Legkikh Splavov, No. 1, 3 (1976).
I. N. Fridlyander,Deformable Aluminum Structural Alloys [in Russian], Metallurgiya, Moscow (1979).
G. L. Shneider, V. G. Kudryashov, G. S. Neshpor, et al., “Variation of the mechanical properties over the thickness for large semifinished products from aluminum alloys of the system Al-Zn-Mg-Cu after softening aging regimes,”Tekhnologiya Legkikh Splavov, No. 8, 4 (1982).
G. L. Shneider, V. K. Zel'tin, A. A. Kalugin, et al., “Investigation of the microstructure and resource characteristics of forgings from aluminum alloy V93pch,”Izv. Akad Nauk SSSR, Metally, No. 6, 100 (1987).
G. L. Shneider, “Effect of the chemical composition on the hardenability of aluminum alloys,”Tsvetnye Metally, No. 2, 55 (1993).
G. L. Shneider, “Calculation of the hardenability of aluminum alloys in articles of different shapes and sizes,”Tekhnologiya Legkikh Splavov, No. 1, 70 (1977).
D. Broek,Fundamentals of Mechanical Failure [Russian translation], Vysshaya Shkola, Moscow (1980).
J. R. Rice and M. A. Johnson, “The role of large crack tip geometry changes in plane strain fracture,” in:Inelastic Behav. Sol. Kanninen, McGraw-Hill (1970), p, 641.
Author information
Authors and Affiliations
Additional information
Translated from Metullovedenie i Termicheskaya Obrabotka Metallov, No. 6, pp. 24–28June, 1995.
Rights and permissions
About this article
Cite this article
Shneider, G.L. Dependence of the static and cyclic crack resistances of large forged semifinished products from aluminum alloys 1933 and V95 on the cooling rate in quenching. Met Sci Heat Treat 37, 243–247 (1995). https://doi.org/10.1007/BF01152227
Issue Date:
DOI: https://doi.org/10.1007/BF01152227