Skip to main content
Log in

A hydrodynamic end seal

  • Published:
Chemical and Petroleum Engineering Aims and scope

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Literature cited

  1. B. S. Zakharov, A. A. Petrosyants, and L. B. Aronov, Calculation, Planning, and Manufacture of End Seals for Chemical and Petroleum Pumps. Review Information [in Russian], TsINTIkhimneftemash, Moscow (1974).

    Google Scholar 

  2. B. S. Nay, “Review of the mechanism of hydrodynamic lubrication in face seals,” in: Proceedings of Third International Conference on Fluid Sealing, BHRA, Paper E5 (1967), pp. 72–120.

  3. B. S. Zakharov and L. A. Novikov, “Investigation of end seals with an eccentric sealing,” Ékspluatatsiya, Modernizatsiya i Remont Oborudovaniya, No. 10, 3–8 (1971).

    Google Scholar 

  4. B. T. Zakharov, A. A. Petrosyants, M. I. Tsvetkov, P. B. Aronov, and Yu. P. Degtyarev, “Improvement in shaft seals for mixing devices and pumps in a polypropylene installation,” Ékspluatatsiya, Modernizatsiya i Remont Oborudovaniya, No. 6, 1–4 (1975).

    Google Scholar 

Download references

Authors

Additional information

Translated from Khimicheskoe i Neftyanoe Mashinostroenie, No. 5, pp. 10–12, May, 1977.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Petrosyants, A.A., Zakharov, B.S., Antsiferova, A.I. et al. A hydrodynamic end seal. Chem Petrol Eng 13, 405–409 (1977). https://doi.org/10.1007/BF01147227

Download citation

  • Issue Date:

  • DOI: https://doi.org/10.1007/BF01147227

Navigation