This is a preview of subscription content, log in via an institution to check access.
Abbreviations
- d:
-
tube diameter
- L:
-
tube length
- P:
-
pressure
- qcr :
-
critical heat flux
- r:
-
heat of evaporation
- X:
-
steam content by mass
- Xrd :
-
steam content by mass at the beginning of the ring-dispersive regime
- ρW:
-
mass flow rate
- ρ′ and ρ″:
-
density of water and steam
- σ:
-
surface tension coefficient
Literature Cited
V. E. Doroshuk, L. L. Levitan, and F. L. Lantsman, “Recommendations for computing burnout in a circular tube with uniform heating,” Teploenergetika, No. 2, 66 (1975).
Recommendations for Calculating Burnout for Boiling Water in Circular Tubes, Preprint IVTAN-1-57 (1980).
D. Groeneveld, S. Cheng, and T. Doan, “1986 AECL-UO critical heat flux transfer lookup table,” Heat Transfer Eng.,7, 47 (1986).
B. S. Petukhov, L. G. Genin, and S. A. Kovalev, Heat Exchange in Nuclear Power Plants [in Russian], Énergoatomizdat, Moscow (1986).
É. A. Boltenko, V. V. Pashichev, O. L. Peskov, et al., Fluid Distribution between Flow Core and Wall in Ring-Dispersive Freon Flow in a Tube [in Russian], Preprint FÉI-804, Obninsk (1978).
E. A. Boltenko, Yu. V. Muranov, and R. S. Pomet'ko, Mass Exchange and Burnout in Steam-Generating Channels [in Russian], Summary FEI-0228, TsNIIatominform, Moscow (1988).
Heat Exchanger Handbook [Russian translation], Vol. 1 (of 2), Énergoatomizdat, Moscow (1987).
N. V. Kozina, V. I. blokhin, V. P. Bobkov, et al., “Bibliography of data on thermohydraulic processes,” At. Énerg.,63, No. 2, 100 (1987).
L. R. Fokin, Handbook Data in the Scientific-Technological Information System [in Russian], IVTAN, Ser. 1, Moscow (1988), No. 5, p. 16.
P. L. Kirillov, O. L. Peskov, and N. P. Serdun', Burnout Control Experiment for Water Flow in Tubes, Ser. 1, Vol. 54, IVTAN, Moscow (1984), No. 6, p. 423.
B. A. Zenkevich, O. L. Peskov, G. A. Petrishcheva, et al., Analysis and Correlation of Experimental Burnout Data for Forced Flow of Boiling Water in Tubes, Atomizdat, Moscow (1969).
V. N. Smolin, V. S. Shpanskii, V. I. Esikov, et al., “Experimental data and calculation methodology for boiling water circulating in tubes with uniform and nonuniform heating,” Problems of Atomic Science and Technology, Ser. Physics and Technology of Nuclear Reactors (1979), No. 5(9).
B. A. Zenkevich, O. L. Peskov, and N. D. Sergeev, Burnout for Internal Water Flow in Uniformly Heated Long Tubes, Preprint FÉI-254, Obninsk (1971).
B. R. Bergel'son, “Burnout for boiling with preheating and forced convection,” Teploénergetika, No. 1, 58 (1980).
L. Landislau, “Effect of pressure on critical thermal fluxes of medium diameters (4 mm),” Seminar materials “TF-78” for CMEA member countries. Thermophysical Investigations for Guaranteeing the Reliability and Safety of Water-Moderated Water-Cooled Nuclear Reactors, CMEA, Budapest (1978).
V. I. Smolin, V. K. Polyakov, and V. I. Esikov, “Burnout in a steam-generating tube,” At. Énerg.,13, No. 4 (1962);16, No. 5 (1964).
D. Lee and J. Obertelly, An Experimental Investigation of Forced Convection Burnout in High Pressure Water, Pt. 1: Round Tubes with Uniform Flux Distribution, AEEW-R213 (1963).
D. Lee, An Experimental Investigation of Forced Convection Burnout in High Pressure Water, Pt. 3: Long Tubes with Uniform and Non-Uniform Axial Heating, AEEW-R355 (1965).
B. Tompson and R. Macbeth, Boiling Water Heat Transfer Burnout in Uniformly Heated Round Tubes: Compilation of World Data with Accurate Correlation, AEEW-R356 (1964).
B. Matzner, Basis Experimental Studies of Boiling Fluid Flow and Heat Transfer at Elevated Pressure, TID-1978 (1963).
A. W. Bennet, G. F. Hewitt, H. A. Kearsey, and R. K. Kee, Measurements of Burnout Heat Flux in Uniformly Heated Round Tubes at 1000 PSIA, AEEW-R5055 (1966).
H. Swensen, I. Carver, and C. Karakala, The Influence of Axial Heat Flux Distribution on the Departure from Nucleate Boiling in Water-cooled Tube, Paper ASME N62-WA-297 (1962).
É. A. Boltenko, V. N. Vinogradov, I. B. Katan, et al., Investigation of the Effect of Tube Diameter on Burnout for Various Flow Regimes, Preprint FÉI-1989, Obninsk (1988).
L. L. Levitan, “Drying burnout in the ring-dispersive flow regime,” in: Hydrodynamics and Heat Exchange [in Russian], Nauka, Moscow (1987), pp. 169–185.
P. L. Kirillov, V. P. Bobkov, V. N. Vinogradov, et al., “Recommendations on computing tube burnout from the experimental data base,” At. Énerg.,59, No. 1, 3 (1985).
S. A. Aivasyan, I. S. Enyukov, and L. D. Meshalkin, Applied Statistics, Investigation of Functions [in Russian], Finansy i Statistika, Moscow (1985), p. 487.
Additional information
Power Physics Institute (FÉI), Obninsk. Translated from Atomnaya énergiya, Vol. 71, No. 1, pp. 18–28, July, 1991
Rights and permissions
About this article
Cite this article
Kirillov, P.L., Bobkov, V.P., Boltenko, É.A. et al. Lookup tables of critical heat fluxes. At Energy 71, 543–551 (1991). https://doi.org/10.1007/BF01137996
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF01137996