Literature cited
V. N. Frolov and Yu. S. Letnikov, Shop Fabrication of Welding Fittings [in Russian], GOSINTI, Moscow (1959), p. 94.
Yu. I. Berliner and A. Kh. Akmukhametov, “Manufacture of short-radius elbows by pressing pipe blanks over corniform mandrel,” Khim. i Neft. Mashinostr., No. 2, 33–34 (1970).
V. D. Taran and R. I. Tavastsherna, “Investigation of process of manufacturing elbows by hot pressforming,” Montazhnye Spetsializirovannye Raboty v Stroitel'stve, No, 2, 12–16 (1964).
V. P. Luk'yanov, “Calculation of force parameters in process of press-forming pipe on corniform mandrel,” Khim. i Neft. Mashinostr., No. 9, 23–25 (1969).
L. E. Al'shevskii, Tractive Forces in Cold Drawing of Pipe [in Russian], Metallurgizdat, Moscow (1952), p. 144.
I. Ya. Tarnovskii, A. A. Pozdeev, O. A. Ganago, et al., Theory of Metal Forming [in Russian], Metallurgizdat, Moscow (1963), p. 672.
S. I. Gubkin, Theory of Metal Forming [in Russian], Metallurgizdat, Moscow (1947), p. 532.
A. A. Dinnik, “True yield points of steel at high temperatures and high rates of deformation,” in: Collected Scientific Works of the Dnepropetrovsk Metallurgical Institute; Metal Forming [in Russian], No. 39 (1960), pp. 118–140.
E. S. Rokotyan and S. E. Rokotyan, Energy-Force Parameters of Blooming and Sheet Mills [in Russian], Izd. Metallurgiya, Moscow (1968), p. 120.
Additional information
Translated from Khimicheskoe i Neftyanoe Mashinostroenie, No. 9, pp. 31–33, September, 1973.
Rights and permissions
About this article
Cite this article
Berliner, Y.I., Klimov, V.N. & Akmukhametov, A.K. Calculation of forces in press-forming pipe on corniform mandrel. Chem Petrol Eng 9, 836–840 (1973). https://doi.org/10.1007/BF01137206
Issue Date:
DOI: https://doi.org/10.1007/BF01137206