Conclusions
It follows from (1) that on the basis of the measurement results it is possible to arrive at the following conclusions: an electrode segment plated with any other thermoelectric material can be represented by an equivalent system consisting of two conductors which are joined only at the ends and have cross sections and lengths respectively equal to those of the main and plated electrodes.
Relationship (1) was used under specific conditions of thermal flow convertors [7] for finding with relative simplicity the optimum plating thickness for a maximum sensing-element signal.
The above data can be used either for evaluating the thermoelectric properties of plated thermocouples, or for manufacturing such thermocouples with predetermined properties.
Similar content being viewed by others
Literature cited
A. D. Dmitrovich, Evaluation of the Thermophysical Properties of Building Materials [in Russian], Gosstroiizdat [State Press of Literature on Building], Moscow (1963).
M. M. Popov, Thermometry and Calorimetry [in Russian], MGU Press (Moscow State University) (1954).
P. D. Lebedev, Teploénergetika [Thermal Engineering] (1956).
S. A. Sukhov, S. Ya. Kadlets, and G. D. Pavlyuk, Ismerit. tekhn., No. 2 (1959).
M. A. Mikheev, Foundations of Heat Transfer [in Russian], Gosénergoizdat, Moscow (1956).
Wilson, Epps. Phys. Soc. Proc., No. 32,(1920), p. 326.
O. A. Gerashchenko, A. D. Lebedev, and V. G. Fedorov, Laminated Transducer of Thermal Flows [in Russian], GOSINTI (State Institute of Scientific and Technical Information), Moscow (1964).
Rights and permissions
About this article
Cite this article
Gerashchenko, O.A., Ionova, N.N. Thermal emf of plated thermocouples. Meas Tech 9, 93–95 (1966). https://doi.org/10.1007/BF01000876
Issue Date:
DOI: https://doi.org/10.1007/BF01000876