Skip to main content
Log in

Application of field-effect transistors for measuring very small direct currents

  • Published:
Measurement Techniques Aims and scope

Conclusions

A study of the properties of field-effect transistors and their application in circuits shows that the quality of electrometric amplifiers with such transistors approaches that of amplifiers with electrometric tubes and capacitive choppers, and in certain instances exceeds it. At the same time this new type of electrometric amplifiers has the following advantages as compared with existing types: it is relatively simple and stable over a wide temperature range, it has a low noise level, low power consumption, a small size and it is suitable for microminiaturization, and a reduction of time required to prepare for operation after switching in. The above properties indicate the advisability of using various types of field-effect transducers in electrometric devices.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

Literature cited

  1. A. N. Karmazinskii, PTé, No. 3 (1965).

  2. S. G. Golub' and B. R. Shul'man, Izmerit. tekhn., No. 11 (1966).

  3. W. Shockley and G. Pearson, “Modulation of conductance of thin films of semiconductors by surface charges,” Phys. Rev.,74 (1948).

  4. W. Shockley, “Unipolar field-effect transistors,” Proc. IRE,40 (November, 1952) pp. 1365–1367.

    Google Scholar 

  5. C. Dacey and I. Ross, “The field-effect transistor,” The Bell System Tech. J.,34 (November, 1955).

  6. J. L. Sevin, Field-Effect Transistors, McGraw-Hill Book Co. (1965).

  7. A. Van der Ziel, “Thermal noise in field-effect transistors,” Proc. IRE,50 (August, 1962).

  8. A. B. Kauffman, “A field-effect transistor under nuclear radiation,” Electronic Ind,23, No. 3 (1964).

  9. R. M. Bird, “Solid-state electrometer amplifier,” Inst. and Control Systems,36 (September, 1963).

  10. K. Barton, “The field-effect transistor used as a low level chopper,” Electron. Engng.,37, No. 444 (1965), also EI KIG No. 15, ref 90, (1965).

  11. H. Fein, “Solid-state electrometers, input capacitance neutralization,” IEEE Trans on BME,11, No. 1–2 (1964).

  12. C. Guld, “Cathode follower and negative capacitance as high input impedance circuits,” Proc. IRE,50 (September, 1962).

  13. W. H. Evans, “A new device for the measurement of static electric fields,” Geophys. Res.,70, No. 16 (1965).

  14. J. H. McQuaid, “Recycling integrator for measuring nanoampere currents,” RSI,36, No. 5 (1965).

  15. Heiman and S. R. Hofstein,“ The insulated gate FET,” presented at Electron Devices meeting, Wash., (October, 1962).

  16. D. M. Griswold, “Understanding and using the MOS FET,” Electronics,37, No. 31 (1964).

  17. H. A. Doong, “A six decade linear response digitized electrometer,” IEEE Trans. on Nuclear Science, No. 5–12 No. 4 (1965).

  18. J. B. McCoslin, “Electrometer for ionization chambers using MOS FET,” RST,35, No. 11 (1964).

Download references

Authors

Rights and permissions

Reprints and permissions

About this article

Cite this article

Kiemin, L.V. Application of field-effect transistors for measuring very small direct currents. Meas Tech 9, 592–596 (1966). https://doi.org/10.1007/BF00975206

Download citation

  • Issue Date:

  • DOI: https://doi.org/10.1007/BF00975206

Keywords

Navigation