Triggering regime of oil-filled trigatron dischargers

  • N. K. Kapishnikov
  • V. M. Muratov
Article
  • 24 Downloads

Abstract

A comparative analysis made in [1, 2] of different types of regulable high-voltage dischargers with liquid insulation showed that trigatrons are currently the most promising for use in high-voltage pulse-operated devices due to their simplicity and reliability. Two basic mechanisms of discharge initiation can be realized in trigatrons — initiation by intensification of the field in the region of the control electrode [2, 3], and triggering by a spark in the ignition gap [4, 5]. The first type of trigatron has been studied sufficiently only for short voltage periods [3, 6, 7], so it is used mainly in switching the pulse-shaping lines of powerful nanosecond pulse generators with “rapid” (0.5–1.5 μsec) charging [8, 9]. Almost no use is now made of the second type of trigatron switch in high-voltage pulse technology due to its unsatisfactory time characteristics. Here we report results of a study of the time characteristics of both types of oil-filled trigatrons operating in a regime whereby they form the leading edge of rectangular voltage pulses with amplitudes up to 800 kV and durations of 1–100 μsec. The goal is to find the optimum conditions for triggering of trigatron dischargers with liquid insulation in the region of microsecond voltage discharges. Experiments were conducted on the unit in [10]. The test discharger was placed in a cylindrical chamber 45 cm in diameter and 27 cm in length. The high-voltage electrode of the discharger was in the form of a cylinder 20 cm in diameter positioned coaxially inside the chamber. The 10-mm-diameter ground electrode was positioned radially in a branch pipe 8 cm long. The control electrode was placed in a 2-cm-diameter hole in the center of the ground electrode. The chamber with the test discharge was filled with transformer oil with a breakdown voltage of about 50 kV. The oil was not replaced or cleaned during the experiment. We did not find that contamination of the oil by discharge products had any effect on the time characteristics of either type of discharger. The results were analyzed by the least squares method, with 50 measurements to a point (it was found that time lag of the discharger triggering conforms approximately to a normal distribution law for both types of discharger).

Keywords

Ground Electrode Nanosecond Pulse Liquid Insulation Branch Pipe Cylindrical Chamber 

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

Literature cited

  1. 1.
    V. Ya. Ushakov, Impulsive Electrical Breakdown of Liquids [in Russian], Tomsk. Univ., Tomsk (1975).Google Scholar
  2. 2.
    V. M. Muratov, “Study of controlled initiation of discharge in water with reference to high voltage nanosecond switches,” Author's Abstract Candidate Dissertation, Tomsk. Politekhn. Inst, Tomsk (1977).Google Scholar
  3. 3.
    V. V. Balalaev, N. K. Kapishnikov, et al., “Megavolt water dischargers of the trigatron type,” Prib. Tekh. Eksp., No. 5 (1977).Google Scholar
  4. 4.
    I. I. Aksenov, V. K. Bocharov, and S. A. Smirnov, “Excitation of a controllable discharge in a liquid,” Preprint FTI (Physico-Technical Institute), Akad. Nauk UkrSSR, Kharkov (1968), No. 193.Google Scholar
  5. 5.
    V. A. Libenson, G. S. Fainberg, and S. A. Smirnov, “Study of discharge in a circuit with controllable ignition in water,” Elekt. Opt. Mekh., No. 4 (1970).Google Scholar
  6. 6.
    N. K. Kapishnikov, V. M. Muratov, and V. Ya. Ushakov, “High-voltage dischargers filled with transformer oil,” Prib. Tekh. Eksp., No. 4 (1978).Google Scholar
  7. 7.
    V. V. Balalaev, N. K. Kapishnikov, et al., “Controllable multichannel discharges with water insulation,” Zh. Prikl. Mekh. Tekh. Fiz., No. 5 (1978).Google Scholar
  8. 8.
    K. A. Zheltov, A. V. Malygin et al., “Heavy-current nanosecond electron accelerator with a stable energy of 1 MeV,” Prib. Tekh. Eksp., No. 5 (1981).Google Scholar
  9. 9.
    R. B. Baksht, A. F. Korostelev, et al., “High-power nanosecond pulse generator SNOP-1,” Prib. Tekh. Eksp., No. 1 (1982).Google Scholar
  10. 10.
    N. K. Kapishnikov and V. M. Muratov, “High-voltage microsecond pulse generator,” EOM, No. 4 (1983).Google Scholar
  11. 11.
    P. P. Shkuropat, “Mechanism of controlled breakdown in a trigatron,” in: Electrophysical Equipment and Electrical Insulation [in Russian], Energiya, Moscow (1970).Google Scholar
  12. 12.
    N. K. Kapishnikov and V. M. Muratov, “High-voltage submicrosecond pulse generator,” Prib. Tekh. Eksp., No. 1 (1984).Google Scholar
  13. 13.
    K. A. Naugol'nykh and N. A. Roi, Electrical Discharges in Water [in Russian], Nauka, Moscow (1971).Google Scholar

Copyright information

© Plenum Publishing Corporation 1987

Authors and Affiliations

  • N. K. Kapishnikov
    • 1
  • V. M. Muratov
    • 1
  1. 1.Tomsk

Personalised recommendations