This is a preview of subscription content, log in via an institution to check access.
Literature Cited
A. N. Guz', “On an approximate method to determine the stress concentration around curvilinear holes in shells,” Prikl Mekh.,8, No. 6, 605–612 (1962).
L. V. Kantorovich, “On the method of steepest descent,” Dokl. Akad. Nauk SSSR56, No. 3, 233–237 (1947).
I. M. Pirogov, “Extension of a curved plate weakened by a hole in which a stiff washer has been pressed,” Dokl. Akad. Nauk Ukr. SSR, No. 5, 512–514 (1958).
I. M. Pirogov, “Extension of a cylindrical plate in which an elastic washer has been pressed,” Izv. Vyssh. Uchebn. Zaved. Mashinostro., No. 5, 33–38 (1961).
V. P. Privarnikova and V. N. Chekhov, “On the question of reinforcing the hole edge in a shell by a thin elastic ring,” in: Theoretical and Applied Mechanics [in Russian], No. 1, Kharkov Univ. (1970), pp. 66–70.
A. A. Samarskii, Introduction to the Theory of Difference Schemes, [in Russian], Nauka, Moscow (1971).
Kh. S. Khazanov, “On the analysis of a cylindrical shell with a stiff circulars washer on the side surface,” Izv. Vyssh. Uchebn. Zaved. Aviats. Tekh., No. 1, 83–87 (1970).
A. N. Guz', I. S. Chernyshenko, V. N. Chekhov, et al., Cylindrical Shells Weakened by Holes [in Russian] Naukova Dumka, Kiev (1974).
K. I. Shnerenko, “Stress concentration round a hole in an orthotropic laminar cylindrical shell,” Prikl. Mekh.,6, No. 6, 105–108 (1970).
Additional information
Institute of Mechanics, Academy of Sciences of the Ukrainian SSR, Kiev. Translated from Prikladnaya Mekhanika, Vol. 15, No. 6, pp. 49–54, June, 1979.
Rights and permissions
About this article
Cite this article
Garashchuk, I.N., Chernyshenko, I.S. Numerical investigation of the stress state of a cylindrical shell with a circular hole. Soviet Applied Mechanics 15, 484–488 (1979). https://doi.org/10.1007/BF00884537
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF00884537