Advertisement

pure and applied geophysics

, Volume 143, Issue 1–3, pp 41–60 | Cite as

Grain size and chemical controls on the ductile properties of mostly frictional faults at low-temperature hydrothermal conditions

  • Norman H. Sleep
Fault Mechanics, Rupture Processes, and Fracture: Theory and Observation

Abstract

A conceptually simple process which establishes a steady grain size distribution is envisioned to control the ductile creep properties of fault zones that mainly slip by frictional processes. Fracture during earthquakes and aseismic frictional creep tend to reduce grain size. However, sufficiently small grains tend to dissolve so that larger grains grow at their expense, a process called Ostwald ripening. A dynamic stedy state is reached where grain size reduction by fracture is balanced by grain growth from Ostwald ripening. The ductile creep mechanism within fault zones in hard rock is probably pressure solution where the rate is limited by diffusion along load-bearing grain-grain contacts. The diffusion paths that limit Ostwald repening are to a considerable extent the same as those for pressure solution. Active Ostwald ripening thus implies conditions suitable for ductile creep. An analytic theory allows estimation of the steady-state mean grain size and the viscosity for creep implied by this dynamic steady state from material properties and from the width, shear traction, and long-term slip velocity of the fault zone. Numerical models were formulated to compute the steady state grain size distribution. The results indicate that ductile creep, as suggested in the companion paper, is a plausible mechanism for transiently increasing fluid pressure within mostly sealed fault zones so that frictional failure occurs at relatively low shear tractions, ∼10 MPa. The relevant material properties are too poorly known, however, for the steady state theory (or its extension to a fault that slips in infrequent large earthquakes) to have much predictive value without additional laboratory experiments and studies of exhumed faults.

Key words

Pressure solution Ostwald ripening fault zones fluid pressure earthquakes 

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

References

  1. Brantley, S. L., Evans, B., Hickman, S. H., andCrerar, D. A. (1990),Healing of Microcracks in Quartz: Implications for Fluid Flow, Geology18, 136–139.Google Scholar
  2. Chester, F. M., Evans, J. P., andBiegel, R. L. (1993),Internal Structure and Weakening Mechanisms of the San Andreas Fault, J. Geophys. Res.98, 771–786.Google Scholar
  3. Dewers, T., andOrtoleva, P. (1990),Differentiated Structure Arising from Mechanochemical Feedback in Stressed Rocks, Earth-Science Rev.29, 283–298.Google Scholar
  4. Dove, P. M. (1993),The Dissolution Kinetics of Quartz in Sodium Chloride Solutions at 25 to 300°C, Am. J. Sci. (submitted).Google Scholar
  5. Dove, P. M., andCrerar, D. A. (1990),Kinetics of Quartz Dissolution in Electrolyte Solutions Using a Hydrothermal Mixed Flow Reactor, Geochim. Cosmochim. Acta.54, 955–969.Google Scholar
  6. Dove, P. M., andElston, S. F. (1992),Dissolution Kinetics of Quartz in Sodium Chloride Solutions: Analysis of Existing Data and a Rate Model for 25°C, Geochim. Cosmochim. Acta.56, 4147–4156.Google Scholar
  7. Hickman, S. H., andEvans, B. (1992),Growth of grain contacts in halite by solution-transfer: Implications for diagenesis, lithification, and strength recovery. InFault Mechanics and Transport Properties of Rocks (eds. Evans, B., and Wong, T.-F.) (Academic Press, London 1992) pp. 253–280.Google Scholar
  8. Fitz Gerald, J. D., andStünitz, H. (1993),Deformation of Granitoids at Low Metamorphic Grade. I: Reactions and Grain Size Reduction, Tectonophys.221, 269–297.Google Scholar
  9. Gratier, J.-P. (1993a),Le fluage des roches par dissolution-cristallisation sous contrainte dans la croûte supérior, Bull. Soc. gél. France164 (2), 267–287.Google Scholar
  10. Gratier, J.-P. (1993b),Experimental Pressure Solution of Halite by an Indenter Technique, Geophys. Res. Lett.20, 1647–1650.Google Scholar
  11. Gratier, J.-P., andGuiguet, R. (1986),Experimental Pressure Solution Deposition on Quartz Grains: The Effect of the Nature of the Fluid, J. Struct. Geol.28, 845–856.Google Scholar
  12. Gratier, J.-P., Chen, T., andHellman, R. (1993),Pressure Solution as a Mechanism for Crack Sealing around Faults Natural and Experimental Evidence, U.S.G.S. Red Book: The Mechanical Involvement of Fluids in Faulting (in press).Google Scholar
  13. Helgeson, H. C., andLichtner, P. C. (1987),Fluid Flow and Mineral Reactions at High Temperatures and Pressures, J. Geol. Soc. Lond.144, 313–326.Google Scholar
  14. Hickman, S. H. (1991),Stress in the Lithosphere and the Strength of Active Faults, Rev. Geophys. Supplement to29, 759–775.Google Scholar
  15. Marqusee, J. A., andRoss, J. (1983),Kinetics of Phase Transitions: Theory of Ostwald Ripening, J. Chem. Phys.79, 373–378.Google Scholar
  16. Marone, C., andScholz, C. H. (1988),The Depth of Seismic Faulting and the Upper Transition from Stable to Unstable Slip Regimes, Geophys. Res. Lett.15, 621–624.Google Scholar
  17. Marone, C. J., Scholz, C. H., andBilham, R. (1988),On the Mechanics of Earthquake Afterslip, J. Geophys. Res.96, 8441–8452.Google Scholar
  18. Parks, G. A. (1984),Surface and Interfacial Free Energies of Quartz, J. Geophys. Res.89, 3997–4008.Google Scholar
  19. Parks, G. A. (1990),Surface Energy and Adsorption at Mineral/Water Interfaces: An Introduction, Rev. Mineralogy23, 133–175.Google Scholar
  20. Raj, R. (1982),Creep in Polycrystalline Aggregates by Matter Transport Through a Liquid Phase, J. Geophys. Res.87, 4731–4739.Google Scholar
  21. Randolph, A. D., andLarson, M. A.,Theory of Particular Processes Analysis and Techniques of Continuous Crystallization (Academic Press, New York 1971), 251 pp.Google Scholar
  22. Robin, P.-Y. F. (1978),Pressure Solution at Grain-to-grain Contacts, Geochim. Cosmochim. Acta.42, 1383–1398.Google Scholar
  23. Rutter, E. H. (1983),Pressure Solution in Nature, Theory and Experiment, J. Geol. Soc. Lond.140, 725–740.Google Scholar
  24. Sammis, C. G., andBiegel, R. L. (1989),Fractals, Fault-gouge, and Friction, Pure and Appl. Geophys.131, 255–271.Google Scholar
  25. Sleep, N. H., andBlanpied, M. L. (1994),Ductile Creep and Compaction: A Mechanism for Transiently Increasing Fluid Pressure in Mostly Sealed Fault Zones, Pure and Appl. Geophys., this issue.Google Scholar
  26. Steefel, C. L., andVan Cappellen, P. (1990),A New Kinetic Approach to Modeling Water-rock Interaction: The Role of Nucleation Precursors, and Ostwald Ripening, Geochim. Cosmochim. Acta.54, 2657–2677.Google Scholar
  27. Stünitz, H., andFitz Gerald, J. D. (1993),Deformation of Granitoids at Low Metamorphic Grade. II: Granular Flow in Albite-rich Mylonites, Tectonophys.221, 299–324.Google Scholar
  28. Wojtal, S., andMitra, G. (1986),Strain Hardening and Strain Softening in Fault Zones from Foreland Thrusts, Geol. Soc. Am. Bull.97, 674–687.Google Scholar
  29. Yund, R. A., Blanpied, M. L., Tullis, T. E., andWeeks, J. D. (1990),Amorphous Material in High Strain Experimental Fault Gouges, J. Geophys. Res.95, 15,589–15,602.Google Scholar
  30. Zoback, M. D. (1991),State of Stress and Crustal Deformation along Weak Transform Faults, Phil. Trans. R. Soc. Lond. A337, 141–150.Google Scholar

Copyright information

© Birkhäuser Verlag 1994

Authors and Affiliations

  • Norman H. Sleep
    • 1
  1. 1.Department of GeophysicsStanford UniversityStanfordU.S.A.

Personalised recommendations