Skip to main content
Log in

Semiempirical method of estimating the heat transfer level behind the boundary-layer separation point

  • Published:
Journal of engineering physics Aims and scope

Abstract

Relationships are obtained for computation of the heat transfer in the boundary-layer attachment domain and within the vortex zone on the basis of an extension of experimental material.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

Literature cited

  1. Filetti and Kayes, “Heat transfer in separation, flow attachment, and stream development domains behind a double obstacle at the entrance to a plane channel,” Trans. ASME, Heat Transfer [Russian translation], No. 2, 51–57 (1967).

    Google Scholar 

  2. A. A. Pyadishyus and G. P. Zigmantas, “Influence of perturbations induced in a boundary layer by surface projections on the regularity of turbulent transfer,” Problems of Turbulent Transfer [in Russian], Inst. Teplo-Massoobmena Akad. NaukBSSR, Minsk (1979), pp. 113–122.

    Google Scholar 

  3. T. Kawamura, “Heat transfer by separated and reattached flow associated with a backward facing step,” Memoirs of Gifu Technical College, No. 12, 1–8 (1977).

    Google Scholar 

  4. N. Seki, S. Fukusako, and T. Hirata, “Heat transfer in separated flow behind a double step at the entrance to a duct,” Bulletin of Faculty of Engineering, Hokkaido University, No. 79, 21–26, 27–32 (1976).

    Google Scholar 

  5. A. J. Ede, “Effect of an abrupt disturbance of the flow on the local heat-transfer co-efficient in a pipe,” Progress Reports, National Eng. Lab., Heat Div., Glasgow, Scotland, July 1957, August, 1959, pp. 135–142.

    Google Scholar 

  6. R. Seban, “Heat transfer in a turbulent separated air flow behind an obstacle in a plate surface,” Trans. ASME, Heat Transfer [in Russian],86, No. 2, 154–161 (1964).

    Google Scholar 

  7. E. M. Sparrow and J. P. Kalejs, “Local convective transfer coefficient in a channel downstream of a partially constricted inlet,” Int. J. Heat Mass Transfer, No. 11, 1241–1249 (1977).

    Google Scholar 

  8. M. K. Boelter, G. Joung, and H. W. Iverson, “An investigation of aircraft heaters, XXVII, distribution of heat transfer rate in the entrance section of a circular tube,” NACA, No. 1451, 18–28 (1948).

    Google Scholar 

  9. A. J. Ede, “Effect of an abrupt disturbance of the flow on the local heat-transfer coefficient in a pipe,” Progress Reports, National Eng. Lab., Heat Div., Glasgow, Scotland, July 1957, August 1959, pp. 162–169.

    Google Scholar 

  10. Crall and Sparrow, “Turbulent heat transfer in flow separation and attachment regions and flow development after attachment in a circular pipe,” Trans. ASME, Heat Transfer [in Russian],88, No. 1, 145–152 (1966).

    Google Scholar 

  11. R. Smyth, “Turbulent heat transfer measurements in axisymmetric external separated and reattached flow,” Lett. Heat Mass Transfer,6, No. 5, 405–412 (1979).

    Google Scholar 

  12. P. P. Zemanick and R. S. Dougall, “Local heat transfer downstream of abrupt circular channel expansion,” ASME Paper No. HT-35, 1–8 (1969).

    Google Scholar 

  13. M. G. Ktalkherman and Ya. I. Kharitonova, “Certain questions of heat transfer in pipes with turbulizers,” Heat and Mass Transfer [in Russian], Vol. 1, Pt. 1, Minsk (1972), pp. 128–131.

    Google Scholar 

  14. T. Ota and N. Kohn, “Heat transfer in the flow separation and attachment domains for axisymmetric flow around a blunt circular cylinder,” Trans. ASME, Heat Transfer [in Russian], No. 1 (1977), pp. 158–160.

    Google Scholar 

  15. N. Nishiwaki, T. Sakuma, and H. Tanaka, “Heat transfer in flow separation domains behind a roughness element,” Heat and Mass Transfer-V [in Russian], Vol. 1, Pt. 1, Inst. Teplo- i Massoobmen Akad. Nauk BSSR, pp. 107–113.

  16. B. A. Bairashevskii, “Investigation of aerodynamics and heat transfer in a wall-bounded jet,” Author's Abstract of Candidate's Dissertation, Minsk (1969).

  17. M. G. Ktalkherman, “Investigation of turbulent separation flows in a channel,” Author's Abstract of Candidate's Dissertation, Novosibirsk (1970).

  18. T. Ota and N. Kohn, “Heat transfer in domains of flow separation and subsequent attachment for the flow around a flat plate with blunt leading edge,” Trans. ASME, Heat Transfer, No. 4, 29–32 (1974).

    Google Scholar 

  19. R. A. Seban, A. Emery, and A. Levy, “Heat transfer to separated and reattached subsonic turbulent flow obtained downstream of a surface step,” J. Aerospace Sci.,26, No. 12, 809–814 (1959).

    Google Scholar 

  20. S. E. Berzoi, “Investigation of heat transfer under conditions of a cavitating turbulizer,” Author's Abstract of Candidate's Dissertation, Moscow (1978).

  21. V. P. Popov and E. A. Vagner, “Investigation of local mass transfer during turbulent air flow around cavities,” Investigation of Nonstationary Heat and Mass Transfer (edited by A. V. Lykov) [in Russian], Minsk (1966), pp. 168–179.

  22. A. I. Leont'ev and B. A. Ryagin, “Heat transfer in the vortex domain during transverse flow around a cylinder,” Zh. Prikl. Mekh. Tekh. Fiz., No. 6, 111–115 (1966).

    Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Additional information

Translated from Inzhenerno-Fizicheskii Zhurnal, Vol. 47, No. 4, pp. 543–550, October, 1984.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Leont'ev, A.I., Ivin, V.I. & Grekhov, L.V. Semiempirical method of estimating the heat transfer level behind the boundary-layer separation point. Journal of Engineering Physics 47, 1134–1139 (1984). https://doi.org/10.1007/BF00869905

Download citation

  • Received:

  • Issue Date:

  • DOI: https://doi.org/10.1007/BF00869905

Keywords

Navigation