Abstract
A procedure is described to calculate operation parameters of hydrostatic plastic medium-lubricated thrust bearings. A comparison is made of predicted and experimental characteristics of bearing operation for plastic and Newtonian lubrication media.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
Literature Cited
N. V. Tyabin, Dokl. Akad. Nauk SSSR,16, No. 1, 29–32 (1954).
V. G. Yasov and M. A. Myslyuk, Izv. Vyssh. Uchebn. Zaved., Neft' Gaz, No. 7, 67–69 (1978).
N. P. Leshchii and A. V. Leshchenko, Dokl. Nauch. Soobshch. L'vov Politekh. Inst., No. 5, 12–17 (1975).
G. Dai and Bird R. Byron, J. Non-Newton Fluid Mech.,8, Nos. 3–4, 349–355 (1981).
Yu. M. Pikus, Izv. Vyssh. Uchebn. Zaved., Mashinostr., No. 6, 41–44 (1973).
Yu. M. Pikus, “Influence of rheological and thermophysical properties of lubricants on hydrostatic lubricating layer characteristics,” Author's Abstract of Candidate's Dissertation (Engineering), Kalinin (1981).
A. I. Nakorchevskii and V. A. Skurchinskii, Plastic Lubricants [in Russian], Kiev (1971), pp. 189–191.
Additional information
Volgograd Polytechnic Institute, Russia. Translated from Inzhenerno-Fizicheskii Zhurnal, Vol. 63, No. 3, pp. 364–367, September, 1992.
Rights and permissions
About this article
Cite this article
Tyabin, N.V., Yablonskii, V.O. & Yashchuk, V.M. Calculation of hydrostatic plastic medium-lubricated thrust bearings. J Eng Phys Thermophys 63, 949–952 (1992). https://doi.org/10.1007/BF00852786
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF00852786