Conclusions
Further improvements in work on metrological product provision should take the following course:
-
1.
Development and timely review of normative-technical documentation on testing norms and methods; unification and standardization of procedures;
-
2.
Drawing up of standards on the characteristics of test facilities and the organization of series output and certification of the facilities; creation of information stores on test equipment;
-
3.
Clear separation of the functions of the test and measurement subdivisions.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
Literature cited
Great Soviet Encyclopaedia [in Russian], Vol. 10, Sov. Entsikl., Moscow.
M. L. Yafori, Aviat. Week, No. 3 (1971).
M. B. Emel'yanov, Product Standards and Quality [in Russian], Standartov, Moscow (1971).
V. V. Popov and V. L. Chapaikin, Izmeritel. Tekh., No. 5 (1975).
State Standard GOST 19118-73 “Electrodynamic vibrational devices, test methods and facilities” (1973).
State Standard GOST 20497-75 “Experimental equipment. Heat, cold, and heat and cold chambers. Certification methods and facilities” (1975).
State Standard GOST 10370-71 “Experimental heat, cold, heat and cold, heat, cold and pressure, and heat, cold and moisture chambers. Types and basic parameters” (1971).
Yu. A. Donde, Izmeritel. Tekh., No. 9 (1974).
Additional information
Translated from Izmeritel'naya Tekhnika, No. 1, pp. 18–20, January, 1977.
Rights and permissions
About this article
Cite this article
Moiseev, L.F. Development and improvement of metrological provisions for product testing. Meas Tech 20, 27–30 (1977). https://doi.org/10.1007/BF00824421
Issue Date:
DOI: https://doi.org/10.1007/BF00824421