Literature cited
GOST 8.051-73 on “Tolerated errors in measuring linear dimensions from 1 to 500 mm.”
B. N. Vorontsov, Izmeritel'. Tekh., No. 6 (1968).
B. N. Vorontsov, Izmeritel'. Tekh., No. 5 (1969).
N. N. Markov et al., Measuring Equipment Errors and Its Selection for Linear Measurements [in Russian], Mashinostroenie, Moscow (1967).
Yu. G. Gorodetskii, Structure, Design, and Utilization of Measuring Gauges and Instruments [in Russian], Mashinostroenie, Moscow (1971).
A. I. Yakusheva (editor), Engineering Plant Inspector's Handbook [in Russian], Mashinostroenie, Moscow.
OMTRM 0466-001-62 on “Selecting measuring equipment for linear measurements from 1 to 500 mm according to the precision of its manufacture.”
GOST 8.103-73 on “Organization and procedure of design and technological documents' metrological examinations.”
Additional information
Translated from Izmeritel'naya Tekhnika, No. 4, pp. 15–17, April, 1976.
Rights and permissions
About this article
Cite this article
Gel'fand, M.Y., Margol'f, V.D. & Solovov, L.S. Metrological examination of technological documents (from the experience of the altai engine plant). Meas Tech 19, 498–501 (1976). https://doi.org/10.1007/BF00822671
Issue Date:
DOI: https://doi.org/10.1007/BF00822671