Conclusions
Accounting for the effect of deviations of standards from correct geometric form in the checking of monitoring-sorting automata, on the one hand, makes it possible, with a great degree of credibility, to determine the accuracy indicators of an automaton, and, on the other hand, permits a reduction of rigid requirements for the manufacturing tolerance for separate deviations of specimens from correct geometric form. In accounting for several deviations from correct geometric form it is necessary to bear in mind that their mutual disposition on a separate standard is nonrandom.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
Literature cited
Kh. B. Kordonski, Standartizatsiya, No. 2 (1958).
M. M. Kempinskii et al., Reliability of Automatic Means of Processing and Monitoring in Machinebuilding [in Russian], Mashinostroenie, Moscow-Leningrad (1967).
M. I. Kochenov, in: Accuracy of Manufacture of Ball and Roller Bearing on Automated Lines [in Russian], Izd. An SSSR, Moscow (1955).
I. V. Dunin-Barkovskii and N. V. Smirnov, Probability Theory and Mathematical Statistics in Technology (General Part) [in Russian], GITTL, Moscow (1955).
Additional information
Translated from Izmeritel'naya Tekhnika, No. 5, pp. 21–23, May, 1973.
Rights and permissions
About this article
Cite this article
Izrailev, V.M. Effect of deviations of standards from correct geometric form on the results of checking monitoring-sorting automata. Meas Tech 16, 664–667 (1973). https://doi.org/10.1007/BF00815805
Issue Date:
DOI: https://doi.org/10.1007/BF00815805