Summary
The main objective of the present paper is the development of a viscoplastic regularization procedure valid for an adiabatic dynamic process for multi-slips of single crystals. The next objective is to focus attention on the investigation of instability criteria, and particularly on shear band localization conditions.
To achieve this aim, an analysis of acceleration waves is given, and advantage is taken of the notion of the instantaneous adiabatic acoustic tensor. If zero is an eigenvalue of the acoustic tensor, then the associated discontinuity does not propagate, and one speaks of a stationary discontinuity. This situation is referred to as the ‘strain localization condition’, and corresponds to a loss of hyperbolicity of the dynamical equations. It has been proved that for an, adiabatic process of rate-dependent (elastic-viscoplastic) crystal, the wave speed of discontinuity surface always remains real and different from zero. It means that for this case the initial-value problem is well-posed. However, for an adiabatic process of rate-independent(elastic-plastic) crystal, the wave speed of discontinuity surface can be equal zero. Then the necessary condition for a localized plastic deformation along the shear band to be formed is as follows: the determinant of the instantaneous adiabatic acoustic tensor is equal to zero. This condition for localization is equivalent to that obtained by using the standard bifurcation method. Based on this idea, the conditions for adiabatic shear band localization of plastic deformation have been investigated for single crystals. Particular attention has been focused on the discussion of the influence of thermal expansion, thermal plastic, softening and spatial covariance effects on shear band localization criteria for a planar model of an f.c.c. crystal undergoing symmetric primary-conjugate double slip. The results obtained have been compared with available experimental observations.
Finally, it is noteworthy that the viscoplasticity regularization procedure can be used in the developing of an unconditionally stable numerical integration algorithm for simulation of adiabatic inelastic flow processes in ductile single crystals, cf. [21].
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Abraham, R.;Marsden, J. E.;Ratiu, T.: Manifolds, tensor analysis and applications. New York: Springer 1988
Asaro, R. J.: Geometrical effects in the inhomogeneous deformation of ductile single crystals. Acta Met. 27 (1979) 445–453
Asaro, R. J.: Micromechanics of crystals and polycrystals. Adv. Appl. Mech. 23 (1983) 1–115
Asaro, R. J.;Rice, R. J.: Strain localization in ductile single crystals. J. Mech. Phys. Solids 25 (1977) 309–338
Chang, Y. W.;Asaro, R. J.: Lattice rotations and shearing in crystals. Arch. Mech. 32 (1980) 369–388
Chang, Y. W.;Asaro, R. J.: An experimental study of shear localization in aluminium-copper single crystals. Acta. Met. 29 (1981) 241–257
Duszek-Perzyna, M. K.;Perzyna, P.: Adiabatic shear band localization in elastic-plastic single crystals. Int. J. Solids Struct 30 (1993) 61–89
Duszek-Perzyna, M. K.;Perzyna, P.: Constitutive modelling of inelastic single crystals for localization phenomena. In: Proc. Symposium Recent Advances in Constitutive Laws for Engineering Materials, ICES'95, Hawaii, July 30–August 3, Rajendran, A.M.; Batra, R.C. (eds.) pp. 70–83, CIMNE, Barcelona 1995
Follansbee, P. S.: High-strain-rate deformation of fcc metals and alloys. In: Murr, L. E.; Staudhammer, K. P.; Meyeres, M. A. (eds.) Metallurgical Applications of Shock-Wave and High-Strain-Rate Phenomena, pp. 451–480, New York: Marcel Dekker 1986
Hill, R.: Acceleration wave in solids. J. Mech. Phys. Solids 10 (1962) 1–16
Hill, R.: On constitutive macro-variables for heterogeneous solids at finite strain. Proc. Roy. Soc. Lond. A1 326 (1972) 131–147
Hill, R.;Rice, J. R.: Constitutive analysis of elastic-plastic crystals at arbitrary strain. J. Mech. Phys. Solids 20 (1972) 401–413
Hutchinson, J. W.: Elastic plastic behaviour of polycrystalline metals and composites. Proc. Roy. Soc. Lond. A1 319 (1970) 247–272
Hutchinson, J. W.: Bounds and self-consistent estimates for creep of polycrystalline materials. Proc. Roy. Soc. Lond. A1 348 (1976) 101–127
Iwakuma, T.;Nemat-Nasser, S.: Finite elasto-plastic deformation of polycrystalline metals. Proc. Roy. Soc. Lond. A1 394 (1984) 87–119
Lisiecki, L. L.;Nelson, D. R.;Asaro, R. J. Lattice rotations, necking and localized deformation in f.c.c. single crystals. Scripta Met. 16 (1982) 441–449
Marsden, J. E.;Hughes, T. J. R. Mathematical foundations of elasticity. New York: Prentice-Hall 1983
Mason, J. J.;Rosakis, A. J.;Ravichandran, R.: On the strain and strain rate dependence of the fraction of plastic work converted to heat: an experimental study using high speed infrared detectors and the Kolsky bar. Mech. Mat. 17 (1994) 135–145
Nemat-Nasser, S.;Obata, M.: Rate-dependent, finite elasto-plastic deformation of polycrystals. Proc. Roy. Soc. Lond. A1 407 (1986) 343–375
Peirce, D.;Asaro, R. J.;Needleman, A.: An analysis of nonuniform and localized deformation in ductile single crystals. Acta Met. 30 (1982) 1087–1119
Peirce, D.;Asaro, R. J.;Needleman, A.: Material rate dependence and localized deformation in crystalline solids. Acta Met. 31 (1983) 1951–1976
Perzyna, P.: Temperature and rate dependent theory of plasticity of crystalline solids. Revue Phys. Appl. 23 (1988) 445–459
Perzyna, P.: Instability phenomena and adiabatic shear band localization in thermoplastic flow processes. XVIIIth Int. Congress of Theoretical and Applied Mechanics, Haifa 1992 Acta Mechanica 106 (1994) 173–205
Perzyna, P.: Crystal thermoviscoplasticity with the evolution of the dislocation substructure. (in preparation for publication)
Perzyna, P.; Korbel, K.: Analysis of the influence of substructure of crystal on the localization phenomenon of plastic deformation. Mechanics of Materials (Submitted for publication), (1995)
Rashid, M. M.;Gray, G. T.;Nemat-Nasser, S.: Heterogeneous deformations in copper single crystals at high and low strain rates. Philosophical Magazine A 65 (1992) 707–735
Rice, J. R.: Inelastic constitutive, relations for solids: an internal-varible theory and its application to metal plasticity. J. Mech. Phys. Solids 19 (1971) 433–455
Rice, J. R.: The localization of plastic deformation., In: Koiter, W. T. (ed.) Proc. 14th Int. Congr. of Theor.Appl. Mech. I, pp. 207–220. Amsterdam: North-Holland 1977
Spitzig, W. A.: Deformation behaviour of nitrogenated Fe−Ti−Mn and Fe−Ti single crystals. Acta Met. 29 (1981) 1359–1377
Taylor, G. I.;Quiney, H.: The latent energy remaining in a metal after cold working. Proc. Roy. Soc. Lond. A1 143 (1934) 307–326
Author information
Authors and Affiliations
Additional information
The paper has been prepared within research programme sponsored by the Committee of Scientific Research under Grant 3 P404 031 07.
Rights and permissions
About this article
Cite this article
Duszek-Perzyna, M.K., Perzyna, P. Adiabatic shear band localization of inelastic single crystals in symmetric double-slip process. Arch. Appl. Mech. 66, 369–384 (1996). https://doi.org/10.1007/BF00803672
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF00803672