Conclusions
-
1.
On the basis of an analysis of a model, an equation has been derived for calculating the work of densification in the DHP of reinforced materials as a function of the plasticity properties of their matrices and the geometric parameters of the composites, with allowance for the distribution of normal stresses over the contact surfaces between the fibers and matrices and also for the friction between these elements.
-
2.
A comparison of experimental and calculated values of specific work of densification in the DHP of copper and nickel base composites reinforced with molybdenum wire has shown that taking into account the above factors increases the accuracy of calculations of work of densification for reinforced materials.
Similar content being viewed by others
Literature cited
D. M. Karpinos, L. I. Tuchinskii, and V. Ya. Fefer, Poroshkovaya Met., No. 2, 43 (1973).
A. D. Tomlenov, Mechanics of Plastic Metalworking Processes [inRussian], Mashgiz, Moscow(1963).
M. V. Storozhev and E. A. Popov, Theory of the Plastic Working of Metals [in Russian], Mashinostroenie, Moscow (1971).
Author information
Authors and Affiliations
Additional information
Translated from Porosh-kovaya Metallurgiya, No. 12 (132), pp. 7–13, December, 1973.
Rights and permissions
About this article
Cite this article
Karpinos, D.M., Tuchinskii, L.I. & Fefer, V.Y. Calculation of the specific work of densification in the dynamic hot pressing of laminated reinforced materials. Powder Metall Met Ceram 12, 951–955 (1973). https://doi.org/10.1007/BF00791734
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF00791734