Advertisement

Metal Science and Heat Treatment

, Volume 24, Issue 10, pp 734–737 | Cite as

Use of bimetallic parts in hydraulic drive pumps

  • S. Z. Sapozhnikov
  • L. A. Perezhogin
  • V. N. Kipriyanova
Technical Information

Conclusions

  1. 1.

    The use of bimetals makes it possible to save up to 80% of the expensive bronze used at present for making distributors of hydraulic pumps.

     
  2. 2.

    On the basis of experiments with Soviet and non-Soviet products it was established that the most promising technological processes of obtaining bimetals are those connected with bearings a bimetal sheet to a cast-iron (steel) base, and those of obtaining the bimetal steel-bronze by the method of joint heating.

     

Keywords

Technological Process Hydraulic Drive Hydraulic Pump Drive Pump Bimetallic Part 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

Literature cited

  1. 1.
    M. G. Kabanov and S. P. Stesin, The Production Technology of Hydraulic Drives [in Russian], Mashinostroenie, Moscow (1974).Google Scholar
  2. 2.
    N. A. Garbuz et al., "Production of bimetallic parts with an antifriction layer", Vestn. Mashinostr., No. 10, 26 (1980).Google Scholar
  3. 3.
    V. V. Vologdin and É. V. Kushch, Induction Soldering [in Russian], Mashinostroenie, Leningrad (1979).Google Scholar

Copyright information

© Plenum Publishing Corporation 1983

Authors and Affiliations

  • S. Z. Sapozhnikov
  • L. A. Perezhogin
  • V. N. Kipriyanova

There are no affiliations available

Personalised recommendations