Conclusions
-
1.
The precipitation of α-phase and iron from solid solution takes place during the annealing of special brass.
-
2.
The α-phase precipitates in the form of needles along crystallographic directions in the cast structure.
-
3.
Only noncoherent dispersed particles are found in the brass structure after annealing, nonuniformly distributed in the matrix.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
Literature cited
Nemethova et al., "Metalografickè štúdium zlievàrenskej mosadze Cu−Zn−Al−Fe−Mn," Zb. VI Metalografickè Sympózium Vysokè Tatry (1986).
Karel et al., "Precipitacne procesy v slievèrenske j zliatine Cu−Zn−Al−Fe−Mn," Zb. VI Metalografickè Sympòzium. Vysokè Tatry (1986).
Selected Powder Diffraction Data for Metals and Alloys, Data Book, International Center for Diffraction Data, Pennsylvania, USA (1978).
Luštik et al., "Kvalitativna configurácia železa v dvojfázovej α+β′ mozadzi," Kovovè Materíaly. Bratislava, No. 2, 23 (1985).
Additional information
Czechoslovakia. Translated from Metallovedenie Termicheskaya Obrabotka Metallov, No. 2, pp. 9–10, February, 1992.
Rights and permissions
About this article
Cite this article
Ramiandravola, L., Lukach, I. & Grigerova, T. Structural and substructural changes during heat treatment of special brass. Met Sci Heat Treat 34, 94–96 (1992). https://doi.org/10.1007/BF00769873
Issue Date:
DOI: https://doi.org/10.1007/BF00769873