Abstract
This paper describes recent analytical and experimental efforts to determine the effects of fibre aspect ratio, fibre spacing, and the viscoelastic properties of constituent materials on the damping and stiffness of aligned discontinuous fibre-reinforced polymer matrix composites. This includes the analysis of trade-offs between damping and stiffness as the above parameters are varied. Two different analytical models show that there is an optimum fibre aspect ratio for maximum damping, and that the predicted optimum aspect ratios lie in the range of actual aspect ratios for whiskers and microfibres when the fibre damping is small. When the fibre damping is great enough, however, the optimum fibre aspect ratio corresponds to continuous fibre reinforcement. Experimental data for E-glass/epoxy specimens are presented for comparison with predictions.
Similar content being viewed by others
Abbreviations
- A c,Af,Am :
-
Cross-sectional area of composite, fibre, and matrix, respectively
- d :
-
Fibre diameter
- E *c ,E *f ,E *m :
-
Complex extensional modulus of composite, fibre, and matrix, respectively.
- E′c,E′f,E′m :
-
Extensional storage modulus of composite, fibre, and matrix, respectively
- E″c,E″f,E″m :
-
Extensional loss modulus of composite, fibre, and matrix, respectively
- G′m :
-
Complex shear modulus of matrix
- G′m :
-
Shear storage modulus of matrix
- i :
-
−11/2
- K :
-
Defined in Equation A9
- K 1 :
-
Defined in Equation A5
- l :
-
Fibre length
- r :
-
Radial distance from centre of fibre
- r 0 :
-
Fibre radius
- R :
-
Radius of representative volume element, or one-half of centre-to-centre fibre spacing
- v f,v m :
-
Volume fraction of fibre and matrix, respectively
- W c :
-
Total strain energy stored in a unit volume of composite
- W f :
-
Strain energy stored in volumev f of fibre
- W m :
-
Strain energy stored in a volumev m of matrix
- W γm :
-
Shear strain energy stored in a volumev m of matrix
- W εm :
-
Extensional strain energy stored in a volumev m of matrix
- w rm :
-
Shear strain energy stored in the matrix inr 0⩽r⩽R
- w f :
-
Extensional strain energy stored in a single fibre
- x :
-
Distance along fibre from end of fibre
- α :
-
Defined in Equation 12
- β :
-
Defined in Equation 2
- β * :
-
Defined in Equation A2
- ε :
-
Extensional (longitudinal) strain
- η c,η f,η m :
-
Extensional loss factor of composite, fibre, and matrix, respectively
- η Gm :
-
Shear loss factor of matrix
- θ :
-
Polar angle measured in a plane perpendicular to fibre axis
- ¯gs c,¯gs f,¯gs m :
-
Average longitudinal stress in composite, fibre, and matrix, respectively
- σ f :
-
Longitudinal stress in fibre
- τ :
-
Shear stress in matrix
- ψ :
-
Defined in Equation 27
References
C. W. Bert andR. R. Clary, in “Composite Materials: Testing and Design (3rd Conference)” ASTM STP 546 (The American Society for Testing and Materials, Philadelphia, 1974) pp. 250–265.
R. F. Gibson andR. Plunkett,Shock and Vibration Digest 9 (2) (1977) 9.
R. F. Gibson andD. G. .Wilson,ibid. 11 (10) (1979) 3.
C. W. Bert, in “Damping Applications for Vibrations Control”, ASME AMD-38 (The American Society of Mechanical Engineers, New York, 1980) pp. 53–63.
D. McLean andB. E. Read,J. Mater. Sci. 10 (1975) 481.
R. F. Gibson andA. Yau,J. Comp. Mater. 14 (1980) 155.
R. Plunkett andC. T. Lee,J. Acoust. Soc. Amer. 48 (1970) 150.
H. L. Cox,Brit. J. Appl. Phys. 3 (1952) 72.
N. F. Dow, “Study of Stresses Near a Discontinuity in a Filament-Reinforced Composite Metal”, General Electric Space Sciences Laboratory Report No. R63SD61 (1963).
B. W. Rosen, “Fibre Composite Materials” (American Society of Metals, Metals Park, Ohio, 1964) ch. 3.
A. Kelly andW. R. Tyson, in “High Strength Materials”, edited by V. F. Zackay (Wiley, New York, 1965) ch. 13.
G. E. Smith andA. J. M. Spencer,J. Mech. Phys. Solids 18 (1970) 81.
W. R. Tyson andG. J. Davies,Brit. J. Appl. Phys. 16 (1965) 199.
A. S. Carrara andF. J. McGarry,J. Comp. Mater. 2 (1968) 222.
T. F. MacLaughlin,ibid 2 (1968) 44.
M. J. Iremonger andW. G. Wood,J. Strain Anal. 4 (1969) 121.
Richard M. Barker andThomas F. MacLaughlin,J. Comp. Mater. 5 (1971) 492.
Z. Hashin,Int. J. Solid Struct. 6 (1970) 539.
R. F. Gibson, A. Yau andD. A. Riegner,Exp. Techniques 6 (1982) 10.
R. F. Gibson andR. Plunkett,J. Comp. Mater. 10 (1976) 325.
“Vibration Damping of Composites Reinforced with Kevlar 49 Aramid, Graphite and Fiberglass”, E. I. duPont de Nemours & Co Textile Fibers Department Memo No. 19, June (1980).
J. V. Milewski, Whiskers and Microfibers, in “Additives for Plastics”, Vol. 1 (Academic Press, New York, 1978).
C. T. Chon andC. T. Sun,J. Mater. Sci. 15 (1980) 931.
S. V. Kulkarni, C. H. Zweben andR. B. Pipes, (eds.) “Composite Materials in the Automotive Industry” (ASME, New York, 1978).
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Gibson, R.F., Chaturvedi, S.K. & Sun, C.T. Complex moduli of aligned discontinuous fibre-reinforced polymer composites. J Mater Sci 17, 3499–3509 (1982). https://doi.org/10.1007/BF00752195
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF00752195